Post Reply 
Airsense 10 Warm Up Option
Author Message
ddefendi Offline

Members

Posts: 18
Joined: Jun 2015

Machine: ResMed AirSense 10 Elite
Mask Type: Nasal pillows
Mask Make & Model: AirFit P10
Humidifier: Built In
CPAP Pressure: 10
CPAP Software: ResScan SleepyHead

Other Comments:

Sex: Male
Location: South Carolina

Post: #1
Airsense 10 Warm Up Option
I know the Airsense 10 models offer a Run Warmup option for the humidifier. This option allows you to pre-heat the water before starting therapy, so that the air is not cold or dry at the beginning of therapy.

I have not been able to find how much time you should allow for warmup, 1min, 5min, 10min before therapy or doesn't it mater?

Dennis
09-03-2015 03:19 PM
Find all posts by this user Post Reply Quote this message in a reply

Donate to Apnea Board
zonk Offline

Advisory Members

Posts: 7,908
Joined: Feb 2012

Machine: A10 AutoSet
Mask Type: Nasal mask
Mask Make & Model: Activa LT
Humidifier: Integrated /ClimateLineAir
CPAP Pressure: 9/13
CPAP Software: ResScan

Other Comments: CPAP since Nov 2010

Sex: Male
Location: Australia

Post: #2
RE: Airsense 10 Warm Up Option
10 minutes perhaps, take about 20 minutes to fully warm up, then keep at that temp for an extra 10 minutes
After that, will goes into cooling mode, if you're not ready to start
09-03-2015 03:38 PM
Find all posts by this user Post Reply Quote this message in a reply
ddefendi Offline

Members

Posts: 18
Joined: Jun 2015

Machine: ResMed AirSense 10 Elite
Mask Type: Nasal pillows
Mask Make & Model: AirFit P10
Humidifier: Built In
CPAP Pressure: 10
CPAP Software: ResScan SleepyHead

Other Comments:

Sex: Male
Location: South Carolina

Post: #3
RE: Airsense 10 Warm Up Option
(09-03-2015 03:38 PM)zonk Wrote:  10 minutes perhaps, take about 20 minutes to fully warm up, then keep at that temp for an extra 10 minutes
After that, will goes into cooling mode, if you're not ready to start

Thanks - Dennis
09-04-2015 12:43 PM
Find all posts by this user Post Reply Quote this message in a reply

Donate to Apnea Board
zonk Offline

Advisory Members

Posts: 7,908
Joined: Feb 2012

Machine: A10 AutoSet
Mask Type: Nasal mask
Mask Make & Model: Activa LT
Humidifier: Integrated /ClimateLineAir
CPAP Pressure: 9/13
CPAP Software: ResScan

Other Comments: CPAP since Nov 2010

Sex: Male
Location: Australia

Post: #4
RE: Airsense 10 Warm Up Option
(09-04-2015 12:43 PM)ddefendi Wrote:  Thanks - Dennis
You're most welcome

[Image: Tea-Pot.jpg]
09-04-2015 03:23 PM
Find all posts by this user Post Reply Quote this message in a reply
Post Reply 


Possibly Related Threads...
Thread: Author Replies: Views: Last Post
Question ResMed AirSense 10 Badjo17 26 2,555 12-04-2016 09:30 AM
Last Post: Arnie51
  [Pressure] new airsense 10 new at this abrun7 7 526 11-19-2016 02:12 PM
Last Post: Sleepster
  Breath too warm when exhaling Stevie1under 5 267 11-15-2016 01:12 AM
Last Post: Stevie1under
  Been about a week with the AirSense 10 for Her Beej 4 406 11-11-2016 09:30 PM
Last Post: Beej
  1st night on new Airsense 10 for her Beej 7 491 11-02-2016 06:08 PM
Last Post: Beej
  Resmed Airsense 10 CPAP data versus Resmed Airsense 10 Autoset data David P. 4 555 10-29-2016 08:42 PM
Last Post: trish6hundred
  [Equipment] Airsense 10 enquiry weeble 6 488 09-29-2016 04:44 PM
Last Post: weeble

Forum Jump:

Who's Online (Complete List)