01-10-2023, 02:52 PM
ResMed Airsense 10 - power flaking out
I have a 2017-vintage ResMed AirSense 10.
Machine had been finicky about powering up with either of two external power bricks. Wiggling the barrel connector helped.
Machine had had trouble turning on but reliably stayed on once running - until last night. Power cut out this morning either as I was waking up or the cutout woke me up.
Known issue? I've seen a couple of posts about re-flowing the cold solder.
Machine had been finicky about powering up with either of two external power bricks. Wiggling the barrel connector helped.
Machine had had trouble turning on but reliably stayed on once running - until last night. Power cut out this morning either as I was waking up or the cutout woke me up.
Known issue? I've seen a couple of posts about re-flowing the cold solder.
