Hello Guest, Welcome to Apnea Board !
As a guest, you are limited to certain areas of the board and there are some features you can't use.
To post a message, you must create a free account using a valid email address.

or Create an Account

New Posts   Today's Posts

[CPAP] resmed s9 auto set error message high temperature fault refer to owners manual
Cpap Will only stay on for a few seconds before turning off and showing the error message "high temperature fault "
Post Reply Post Reply
Pull the water tank. Depress the latch on the back and separate the humidifier from the blower unit. Then connect a 22mm CPAP hose directly to the blower. If it runs, then the humidifier is defective.

Oh, and check the intake filter on the blower unit, if it's really dirty, it could impede airflow and actually overheat the blower motor.

It may be Kaput.
Post Reply Post Reply
HI beebsdaddy49,
WELCOME! to the forum.!
Sounds like something is overheating, take the advice in the post above mine.
Good luck with getting your machine working again and also with your CPAP therapy.
Post Reply Post Reply

Possibly Related Threads...
Thread Author Replies Views Last Post
  Advise a New Guy [on high pressure readings] zzzZorro 55 2,846 10-17-2017, 10:26 AM
Last Post: SarcasticDave94
  Auto to manual BPM experiment tmoody 16 493 10-16-2017, 08:58 AM
Last Post: tmoody
Grin New High Score!! jhurlbut 8 279 10-12-2017, 02:22 PM
Last Post: Miastar
Wink Experiencing High Leak Rate (ResMed S9) sleepy Bruce 1 159 10-08-2017, 08:37 AM
Last Post: Sleeprider
  Very High Leak Rate Grmato10 94 4,804 10-08-2017, 01:46 AM
Last Post: trunkizback
  reading high amount of central apneas while on machine but not sleeping ronstar77 59 2,728 10-03-2017, 08:47 AM
Last Post: Sleeprider
  I changed my resmed AirSense 10 Autoset to auto jasonarmstrong 6 423 09-20-2017, 12:29 PM
Last Post: jasonarmstrong

Forum Jump:

New Posts   Today's Posts

About Apnea Board

Apnea Board is an educational web site designed to empower Sleep Apnea patients.

For any more information, please use our contact form.