Hello Guest, Welcome to Apnea Board !
As a guest, you are limited to certain areas of the board and there are some features you can't use.
To post a message, you must create a free account using a valid email address.

or Create an Account


New Posts   Today's Posts

EPR vs PS - same?
#1
EPR vs PS - same?
I heard it said multiple times and my sleep doctor also mentioned PS is different from EPR even at the same setting.

Is this true? Are EPR 3.0 and PS 3.0 different in their net effect?

I was just comparing my pressure curves w/ 3.0 EPR vs 5.0 PS and they look pretty similar.

   

   
Post Reply Post Reply
#2
RE: EPR vs PS - same?
If you look at the mask pressure graph from a Vauto and Airsense CPAP, both produce identical pressure curves. The Airbreak project which used Autoset machines and converted them to enable Aircurve algorithms, demonstrated that the pneumatic block and main board is identical across the Airsense and Aircurve series (CPAP, APAP, VPAP-S, VPAP Auto, ASV, ST, IVAPS), but differs in firmware to control the unit. The mechanism used to produce bilevel pressure and EPR is identical, differing only in the firmware used to produce the EPAP and IPAP pressure and transition. We have more controls with the Aircurve bilevel machines, but those time of inspiration, trigger and cycle controls and even backup rates are all driven by software, not hardware differences. Decide for yourself, but a sleep doctor is not a PAP designer, and apparently not very aware of just how similar the machines are.
Sleeprider
Apnea Board Moderator
www.ApneaBoard.com

____________________________________________
Download OSCAR Software
Soft Cervical Collar
Optimizing Therapy
Organize your OSCAR Charts
Attaching Files
Mask Primer
How To Deal With Equipment Supplier


INFORMATION ON APNEA BOARD FORUMS OR ON APNEABOARD.COM SHOULD NOT BE CONSIDERED AS MEDICAL ADVICE. ALWAYS SEEK THE ADVICE OF A PHYSICIAN BEFORE SEEKING TREATMENT FOR MEDICAL CONDITIONS, INCLUDING SLEEP APNEA. INFORMATION POSTED ON THE APNEA BOARD WEB SITE AND FORUMS ARE PERSONAL OPINION ONLY AND NOT NECESSARILY A STATEMENT OF FACT.
Post Reply Post Reply
#3
RE: EPR vs PS - same?
Since the maximum EPR value is 3 cm, you should be comparing both at 3.   The "R" in EPR stands for relief, meaning "take away from".  The "S" in PS stands for support, meaning "add to".  So with EPR, you subtract its value from the set pressure to obtain the exhalation pressure.   On a PS setting, you add its value to the EPAP value.  The IPAP setting on a VAuto is a maximum limit setting, unless you are in the "S" mode.  The S-mode only has EPAP and IPAP and no PS settings, since the EPAP and IPAP in this mode control the PS value.

- Red
Crimson Nape
Apnea Board Moderator
www.ApneaBoard.com
___________________________________
Useful Links -or- When All Else Fails:
The Guide to Understanding OSCAR
OSCAR Chart Organization
Attaching Images and Files on Apnea Board
Apnea Helpful Tips

INFORMATION ON APNEA BOARD FORUMS OR ON APNEABOARD.COM SHOULD NOT BE CONSIDERED AS MEDICAL ADVICE. ALWAYS SEEK THE ADVICE OF A PHYSICIAN BEFORE SEEKING TREATMENT FOR MEDICAL CONDITIONS, INCLUDING SLEEP APNEA. INFORMATION POSTED ON THE APNEA BOARD WEB SITE AND FORUMS ARE PERSONAL OPINION ONLY AND NOT NECESSARILY A STATEMENT OF FACT.
Post Reply Post Reply



New Posts   Today's Posts


About Apnea Board

Apnea Board is an educational web site designed to empower Sleep Apnea patients.