Hello Guest, Welcome to Apnea Board !
As a guest, you are limited to certain areas of the board and there are some features you can't use.
To post a message, you must create a free account using a valid email address.

or Create an Account


New Posts   Today's Posts

Hose to Mask Interface
#1
Hose to Mask Interface
What is the preferred method for removing the mask from its supply hose? I found that my Quattro FX mask has what appears to be a "quick disconnect" at it swivel point. That seems better than pulling the soft rubber hose off the mask, which I imagine would eventually weaken the rubber connection.

Since I wash the mask every morning, it gets disconnected and reconnected every day.

Thanks
Post Reply Post Reply
#2
RE: Hose to Mask Interface
You could snap the swivel elbow as the fitting guide shows but I prefer to disconnect from the hose rubber cuff its gentler on my nose.
Post Reply Post Reply
#3
RE: Hose to Mask Interface
(06-15-2012, 05:41 PM)zonk Wrote: You could snap the swivel elbow as the fitting guide shows but I prefer to disconnect from the hose rubber cuff its gentler on my nose.

This is after the mask is off my face so there's no discomfort..

Post Reply Post Reply
#4
RE: Hose to Mask Interface
Okay
Post Reply Post Reply
#5
RE: Hose to Mask Interface
I have the Quattro Mirage FFM with what I suspect is the same type of adapter and have have been disconnecting it from the mask every morning for over five years with no change in the way it fits onto the mask.
I would be more worried about wearing our the hard plastic on the mask and swivel than about the rubber adapter.
Post Reply Post Reply
#6
RE: Hose to Mask Interface
I think that while our masks are way different they have a similar connector. I disconnect the swivel. The elbow snaps into what I can only describe as a grommet and the hose attaches to the elbow. I actually take that grommet out after I disconnect the elbow as well. It is the perfect hiding place for little germies and other grime that I would rather not have around. It was a little scary the first time I did it (since the instructions from the DME went kinda like "Looks like it fits, there ya go!") but I figured I'd just yell about it falling apart and get a new one (I can be such a pain!) but it was no problem at all. I was just very careful with the mask as the membranes of the masks now a days seem so fragile! But I have cleaned it this way several times now and had no issues. Good luck!
As always, YMMV! You do not have to agree or disagree, I am not a professional so my mental meanderings are simply recollections of things from my own life.

PRS1 - Auto - A-Flex x2 - 12.50 - 20 - Humid x2 - Swift FX
Post Reply Post Reply
#7
RE: Hose to Mask Interface
Second reply:
After getting up this morning and taking the hose off my mask and thinking about this thread I realized I have committed the procedure to unconscious memory - sort of like riding a bicycle without having to think about balancing. The mask and hose parts are not like what I was thinking when I made my first reply.

Now I realize the mask adapter that fits on hose is not rubber. The end of the hose is rubber and the hard plastic adapter slides into it. When I take the hose off of the mask I pull the adapter off the swivel.
I thought the OP was pulling the swivel out of the mask which didn't seem to be a good idea.

If the OP was saying that he pulls the adapter off the mask swivel, then that is what I do also. It's quicker than getting the hose off the adapter.

In any case I don't think it makes much difference how you do it. The hose gets replaced every so often so wear really doesn't matter and if the swivel wears or breaks it is replaceable.
Post Reply Post Reply
#8
RE: Hose to Mask Interface
I often get up at night to visit the washroom; rather than removing the entire mask from my face I simply break away the swivel from the mask.... I believe this is of no great consequence to the hard plastic mask nor the the hard plastic swivel as I have been doing it for two years on my four masks (Quattros) and they are none the worse for wear. In fact, I also remove the swivel elbow from the mask when I wash and then disinfect the setup (and the cushions come off and the forehead brace, etc.). When returning to bed after a washroom call I simply plug the hard plastic swivel elbow back into the hard plastic mask casing and go back to sleep.

When washing, it is a good thing to wash properly..... you are unlikely to have a problem by simply swishing the whole thing in hot soapy water and drying but I am anal about germs having spent almost a month in hospital on full life support three years ago due to acute bacterial pneumnia that blossomed so fast we had no chance to hit it before I was unconscious and on a stretcher on the way to the hospital with lights and siren. I am here only by the grace of the Great Architect of the Universe. The ambulance was sitting a block away and was here in under a minute or two. The hospital is two blocks away. The emerg was not busy and there were ER technicians and MD's available to see me when I arrived unconscious. There was ONE ventilator available in an isolation unit in CRITICAL care and I was on it within minutes of arriving, tube down my gullet and the whole nine yards. I had venious and arterial taps put in all the way up my arm across my chest and down the other arm. And so on. Nothing was working to bring me back and kill the bacterial infection. NOTHING WAS WORKING TO FIX ME!! Did you get that? NOTHING. They asked my wife if they could unplug me in the third week as it was unlikely that I would return from the dark side as anything more than a veggie. She said no chance. I awoke two or three days later to two doctors standing at the foot of my bed arguing about unplugging me and putting me on straight oxygen and more morphine (getting the picture?). They put me on oxygen first.... on BIPAP respiration and a day or two later on simple oxygen. It was like being tossed into a lake. I could not breathe and I was awake while this was happening. I sucked for air for all I could...... for my LIFE! And I made it through. On that very day they had me out of bed and into a chair. Took three husky orderlies... my feet brushed the floor although they were carrying me 100%. They watched me in the chair for 5 minutes and then dragged me back into the bed. The next day they wheeled me to "storage". No step down. Storage, where they store those that are catatonic, etc. I struggled my way back to the bright side.... I could not stand, roll over in bed, clean myself, go to the washroom, eat, swallow, drink, NOTHING. Get the picture? NOTHING!! A week later, the moment I could sit up with help I was unceremoniously ejected from the hospital to fend for myself at home. They wheeled me out to curbside and said "bye bye". The first year was a constant struggle and to be quite honest, in this, the third year, it still is a struggle but I get out and about as best I can. I have every specialist you can imagine and it is only through self diagnosis, advocacy, education and the Will of the Almighty that I am here today and returning to a normal life for the Golden Years (which, by the way, are not gold.... that's rust friends, not gold... it's R.U.S.T.!)

So I say to you without a moment's hesitation, only YOU are your best advocate. Add to that a loving spouse and loving children and family and you have a good chance at survival. DON'T GO THERE if you can help it. And one of the things I must tell you is that "CLEANLINESS IS NEXT TO GODLINESS" AND THAT 'UNCLEAN WILL PUT YOU NEXT TO YOUR MAKER IN SHORT ORDER AT SOME POINT'.

I have four masks which I rotate, using each for one week at a time and wiping each down with an antiseptic wipe made for respiration equipment each morning. At no more that one week I take that mask and toss it into a basket. It is germ laden. (For those of us that have taken the time..... you can't see them with the naked eye gang). I move on to the next clean mask and so on through all four (now five) of my Quattro masks..... then I fill up the sink with odor free detergent/soap and let them soak for an hour or three and wash using a soft bristles paint brush to get into all the nooks and crannies; rinse thoroughly to get rid of the gunk you just rinsed off; put an ounce of Control III germicide into a gallon of water in the sink and toss everything back in for an hour or three and agitate; rinse very thoroughly in warm water to make sure all of the germicide is gone. Air dry. Reassemble and toss into ziplock baggies. And you are ready to go again. When I am using my humidifier, the tanks get the same treatment and I use only medical grade distilled water from the pharmacy in the tank. Tap water, regardless of how clean you think it is, is water that is not 100% clean. it will leave miniral deposits inside the tank that will eventually ruin the tank but more importantly will give germs a place to hide. DONT USE IT! I wash the tubing in the same manner. Be germ free at all costs, trust me... I have the T shirt.

Rinse the swivel parts especially well as the tiniest bit of soap or foreign matter left inside them will cause them to squeek all night. Otherwise they are self lubricating and should not require any form of lubrication.

DO NOT put any foreign matter, scents, Vaporub, or whatever into the humidifer tank or anywhere else. NOTHING. If it is not intended to be in your lungs do not place it there. It may not seem to be distressing your lungs but eventually it may kill you. And I do not say this lightly, believe me.

Sorry to ramble along; I hope that what I have taken the time to write has struck a chord with just one person....

----------------------------------------------------------------------------
Educate, Advocate, Contemplate.
Herein lies personal opinion, no professional advice, which ALL are well advised to seek.



Post Reply Post Reply
#9
RE: Hose to Mask Interface
Toronto, Great and eye opening post.....no pun intended.
Post Reply Post Reply
#10
RE: Hose to Mask Interface
Thanks, scary story... glad you're still with us!
Post Reply Post Reply


Possibly Related Threads...
Thread Author Replies Views Last Post
Question Hose volume Willw 4 236 02-26-2024, 04:53 PM
Last Post: Willw
  [Equipment] ResMed S9 Elite CPAP – Climate hose problem drewb6111 2 228 01-28-2024, 08:24 PM
Last Post: drewb6111
  How often to replace mask, hose, etc. bigla6940 6 578 12-30-2023, 07:00 AM
Last Post: bigla6940
  Do I have to "clean" my heated CPAP hose? Labromaniac 13 1,289 12-28-2023, 04:23 PM
Last Post: Palmtrees
  Oxygen into CPAP hose when at high altitude Lfmichel 4 543 12-20-2023, 09:39 AM
Last Post: UnicornRider
  [Equipment] Airsense 11 Heated Hose MJLeveille 3 638 12-12-2023, 05:18 PM
Last Post: robbob2112
  [CPAP] Top Hose vs. Bottom Hose Jose Castro 19 1,554 11-03-2023, 10:33 AM
Last Post: Jose Castro


New Posts   Today's Posts


About Apnea Board

Apnea Board is an educational web site designed to empower Sleep Apnea patients.