Hello Guest, Welcome to Apnea Board !
As a guest, you are limited to certain areas of the board and there are some features you can't use.
To post a message, you must create a free account using a valid email address.

or Create an Account


New Posts   Today's Posts

[How to] How to Disconnect a CPAP Hose
#1
Quite a few people find it hard to disconnect a CPAP hose from time to time. I think I've found the best technique.

Here's my wiki on How to Disconnect a CPAP Hose

Get the free SleepyHead software here.
Useful links.
Click here for information on the main alternative to CPAP.
If it's midnight and a DME tells you it's dark outside, go and check it yourself.
Post Reply Post Reply
#2
While your at it, just started using my Resmed S9 Autoset and am using the standard hose, it also came with a "climate line" hose, any tips how to connect it to the machine?
Post Reply Post Reply
#3
G'day Muntineer. The Climateline hose only connects to the humidifier, not to the main blower. Just under the connector in the back of the humidifier is an electrical connector covered by a plastic cap. Pull off the cap, plug the hose into the connector then twist 90 degrees so the electrical connectors on the hose click into the contacts on the humidifier. Easier to do than explain. Smile
DeepBreathing
Apnea Board Moderator
www.ApneaBoard.com


Bed

INFORMATION ON APNEA BOARD FORUMS OR ON APNEABOARD.COM SHOULD NOT BE CONSIDERED AS MEDICAL ADVICE. ALWAYS SEEK THE ADVICE OF A PHYSICIAN BEFORE SEEKING TREATMENT FOR MEDICAL CONDITIONS, INCLUDING SLEEP APNEA. INFORMATION POSTED ON THE APNEA BOARD WEB SITE AND FORUMS ARE PERSONAL OPINION ONLY AND NOT NECESSARILY A STATEMENT OF FACT.
Post Reply Post Reply


#4
(09-28-2014, 07:03 AM)DeepBreathing Wrote: G'day Muntineer. The Climateline hose only connects to the humidifier, not to the main blower. Just under the connector in the back of the humidifier is an electrical connector covered by a plastic cap. Pull off the cap, plug the hose into the connector then twist 90 degrees so the electrical connectors on the hose click into the contacts on the humidifier. Easier to do than explain. Smile
Thanks for that, ah the plastic cap, that's what had me bamboozled, couldn't work out where it was all going to fit in! Thanks
Post Reply Post Reply
#5
You really have to be careful on that H5i humidifier. I think one of the weak points in that design is the plastic 22mm nipple and plastic lock ring.
It's easy to replace if broken -- but only if you can get the parts.
INFORMATION ON APNEA BOARD FORUMS OR ON APNEABOARD.COM SHOULD NOT BE CONSIDERED AS MEDICAL ADVICE. ALWAYS SEEK THE ADVICE OF A PHYSICIAN BEFORE SEEKING TREATMENT FOR MEDICAL CONDITIONS, INCLUDING SLEEP APNEA. INFORMATION POSTED ON THE APNEA BOARD WEB SITE AND FORUMS ARE PERSONAL OPINION ONLY AND NOT NECESSARILY A STATEMENT OF FACT.
Post Reply Post Reply
#6
Just remember to "Break a Branch" .. hold the hose connectors and pretend you are breaking a stick in half, this is how I was taught to disconnect my mask hose from the hose to the machine. The hose will disconnect with very little effort doing it this way.
Post Reply Post Reply




Possibly Related Threads...
Thread Author Replies Views Last Post
  My hose management creation CrazyDreamer 15 412 05-24-2017, 12:59 PM
Last Post: Mosquitobait
  Air Leaking from hose connector? aplatonov 16 11,848 05-20-2017, 01:11 PM
Last Post: Fstrath
  Humidifier/Heated Hose Usage during Summer pcplus2 7 191 05-19-2017, 09:59 PM
Last Post: trish6hundred
  Heated Hose Damaged? Mosquitobait 8 274 05-02-2017, 02:50 PM
Last Post: Mosquitobait
  Modification to Reduce noise in Dreamstation from hose to mask stephennic 16 2,413 04-18-2017, 08:13 PM
Last Post: midgarden
  Heated Hose --yes or no Matzaball2016 7 408 04-16-2017, 05:34 PM
Last Post: Mosquitobait
  Hose too short for wrap around wishicansleep 12 435 03-24-2017, 08:28 AM
Last Post: Cranberry Ray

Forum Jump:

New Posts   Today's Posts




About Apnea Board

Apnea Board is an educational web site designed to empower Sleep Apnea patients.

For any more information, please use our contact form.