Hello Guest, Welcome to Apnea Board !
As a guest, you are limited to certain areas of the board and there are some features you can't use.
To post a message, you must create a free account using a valid email address.

or Create an Account

New Posts   Today's Posts

Intellipap Autoset data cable/adapter?
I just got one of these machines. I had one several years ago and liked it a lot, and I believe I must have had the data cable and software for it as well since I remember looking at the data quite a bit. But of course I can't find the cable anywhere now. I'm planning on using Sleepyhead software this time around.

Looking at the machine, it appears that the data port is via a female PS/2 connector. Looking at the ~ $40 IntelliPAP firmware Upgrade Cable kit seems to indicate that this consists of one USB-to-9-pin cable, and one PS/2-9-pin cable.

If this is true, than all that's really needed to get data off the machine would be a male PS/2-USB adapter (or cable) (price approximately $1.50). Can someone verify this for me? Is there anything else that's required in terms of additional firmware (this is a new machine)?
Post Reply Post Reply

Donate to Apnea Board  
Those of us with long memories are confused... Which PS/2 connector is it? There was a big five-pin connector (DIN-5) and a miniDIN-5. The big one was also used for MIDI cables. And the small one came in configurations from four to nine pins. So check carefully... And that 9-pin to USB cable could be a serial to USB adapter. Of course the standard serial protocol is totally different from the PS/2 keyboard/mouse protocol. You can't tell just by looking.

Tl;dr Spend the bucks for the cable kit they sell.
Post Reply Post Reply
Hi ghmerrill,
WELCOME! to the forum.!
Hang in there for more answers to your question and much success to you as you continue your CPAP therapy.
Post Reply Post Reply

Possibly Related Threads...
Thread Author Replies Views Last Post
  IntelliPap Pressure setting LSalings 0 41 Yesterday, 09:19 PM
Last Post: LSalings
  SD Data Card Erasing data yogigupta 4 179 01-30-2018, 10:42 AM
Last Post: kiwii
  Clinician mode for Intellipap 2 AZCraig 4 1,215 10-29-2017, 08:15 PM
Last Post: analog
  Transfer IntelliPAP Smartlink Module between machines? firecat 1 149 10-06-2017, 02:13 PM
Last Post: trish6hundred
  [Equipment] ResMed AirSense 10 AutoSet: Mask Type & Data Recording foco 7 609 10-01-2017, 07:04 PM
Last Post: sonicboom
  [Equipment] Intellipap 2 Compliance wrenny4fam 4 256 09-06-2017, 11:38 AM
Last Post: wrenny4fam
  Sleepyhead data vs. Doctor's data Daisylouu 10 3,047 08-03-2017, 10:45 PM
Last Post: Mosquitobait

Forum Jump:

New Posts   Today's Posts

About Apnea Board

Apnea Board is an educational web site designed to empower Sleep Apnea patients.