RE: Internal Power Connector AirSense 10
Call
Supplier #27 who is an authorized repair facility. The CEO has been a member on this and other forums, currently inactive. They might sell you the part.
http://www.apneaboard.com/forums/Thread-...9#pid98309 HE self-identifies in this post
01-16-2021, 12:46 PM
(This post was last modified: 01-16-2021, 12:49 PM by terrycts.)
RE: Internal Power Connector AirSense 10
(01-16-2021, 12:21 PM)Crimson Nape Wrote: The best I can tell it is a 4 amp - 24 volt power jack connector. There is a 2.1x5.5 DC power jack on Digi-key. Its P/N is: 486-3380-ND and sells for a $1.64.
Also, here is a PDF listing of the most common power jacks, https://cdn.sparkfun.com/datasheets/Prot...-028-1.pdf
I hope this helps.
The P/N you listed is not it, but I think the common power jacks pdf includes the jack. Problem is I want the custom part which would also include the board. Used is OK.
(01-16-2021, 12:27 PM)Sleeprider Wrote: Call Supplier #27 who is an authorized repair facility. The CEO has been a member on this and other forums, currently inactive. They might sell you the part. He http://www.apneaboard.com/forums/Thread-...9#pid98309 self-identifies in this post
I will follow up on this on Monday. Thank you!
RE: Internal Power Connector AirSense 10
I read your post above immediately after I created the previous post. The board that you refer to is more than likely a Resmed manufactured design. I've gone back and measured my power supply plug and have found that the one that I listed above isn't correct. My power plug measures 7.3 mm OD with a 5.0 mm ID and a recessed pin that I am unable to measure. I will continue to look for a replacement. I'm sure someone else will be needing this in the future.
RE: Internal Power Connector AirSense 10
(01-16-2021, 01:01 PM)Crimson Nape Wrote: I read your post above immediately after I created the previous post. The board that you refer to is more than likely a Resmed manufactured design. I've gone back and measured my power supply plug and have found that the one that I listed above isn't correct. My power plug measures 7.3 mm OD with a 5.0 mm ID and a recessed pin that I am unable to measure. I will continue to look for a replacement. I'm sure someone else will be needing this in the future.
RE: Internal Power Connector AirSense 10
I came across this little tidbit on Wikipedia :
OD: 7.4
ID: 5.5
Pin Dia.: 0.5
Barrel Length: 12.5
Used on: Some Asus, Dell, HP, Sony laptop computers; Dyson hand-held vacuum cleaners
I guess they need to add Resmed 10 series to that list.
