Hello Guest, Welcome to Apnea Board !
As a guest, you are limited to certain areas of the board and there are some features you can't use.
To post a message, you must create a free account using a valid email address.

or Create an Account


New Posts   Today's Posts

Masks, mouth-breathing
#11
RE: Masks, mouth-breathing
I have been using 3M's Nexcare surgical water-resistant tape available at drug stores everywhere.  I haven't had any eruptions or obvious dermal distress due to the adhesives they use.
Post Reply Post Reply



Donate to Apnea Board  
#12
RE: Masks, mouth-breathing
(02-26-2019, 12:38 PM)mesenteria Wrote: I have been using 3M's Nexcare surgical water-resistant tape available at drug stores everywhere.  I haven't had any eruptions or obvious dermal distress due to the adhesives they use.

Thanks. I just visited my local drugstore, which had a number of 3M Nexcare tapes. I bought a roll of tan-colored 1 1/2" "absolute waterproof tape" which is rated "medium hold" on their chart on the package's back. The Nexcare line carried in the store also included a 1" "flexible clear tape" and a 2" "gentle paper tape," both of which were also rated "medium hold." I noticed on the package for the paper tape that it was marked "for frequent changes -- 24-hour hold, non-irritating" and also "Hospital Name: 3M Micropore Surgical Tape." Hmm, so that particular one sounds like what I've already been trying.

Is the usual thing to cut the tape pretty short just to cover the lip area? I was using ~7" long strips of Micropore tape, on the theory that I wanted to make sure the mouth stayed closed. (Or maybe I've watched too many movies where kidnap victims get their mouths taped shut.) Maybe I should keep the tape shorter.

I also ordered an Amara View mask today, so we'll see how that works out.
Post Reply Post Reply
#13
RE: Masks, mouth-breathing
shorter tape. your jaw is just about the strongest muscle you have.  It will rip off pretty much any tape it really wants too.  I form it so you could see my lips shape. it is more taping the lips than taping the mouth. Its purpose is to keep air in, not your mouth shut.  Many say to keep a tab on the end for easy removal.
Fred Bonjour - Project Manager and Lead Tester for OSCAR - Open Source CPAP Analysis Reporter 
OSCAR

Download OSCAR
New to Apnea? Helpful tips to ensure success
Mask Primer
Dealing with a DME
Organize Charts
Attaching Charts

INFORMATION ON APNEA BOARD FORUMS OR ON APNEABOARD.COM SHOULD NOT BE CONSIDERED AS MEDICAL ADVICE. ALWAYS SEEK THE ADVICE OF A PHYSICIAN BEFORE SEEKING TREATMENT FOR MEDICAL CONDITIONS, INCLUDING SLEEP APNEA. INFORMATION POSTED ON THE APNEA BOARD WEB SITE AND FORUMS ARE PERSONAL OPINION ONLY AND NOT NECESSARILY A STATEMENT OF FACT.
Post Reply Post Reply
#14
RE: Masks, mouth-breathing
Try the Dreamwear Full Face Mask. It does not cover your nose but sits right under your nostrils.
Post Reply Post Reply



Donate to Apnea Board  
#15
RE: Masks, mouth-breathing
(02-26-2019, 06:06 PM)Dyssomniac Wrote: ...Is the usual thing to cut the tape pretty short just to cover the lip area? I was using ~7" long strips of Micropore tape, on the theory that I wanted to make sure the mouth stayed closed. (Or maybe I've watched too many movies where kidnap victims get their mouths taped shut.) Maybe I should keep the tape shorter...

We might find it differently, but I will explain my method and what has been reliable for me:

I tear off enough that both ends extend approximately 1/2" past either corner of my mouth.  

However, I fold over one end so that there is a non-stuck tab approximately 1/8" which I can easily take hold of and use to peel the tape off.  I found this handy trick the hard way; I awoke only once to find both nostrils stuffed up and me clawing at my face.  The next night, I had a tab in place.   Don't worry, this has yet to be repeated...it seems to be a rare experience.

So, firstly, I make sure my mouth surface is clean.  No oils, food, schmutz...whatever, and in my case that my face is clean-shaven, or nearly so.

I purse my lips somewhat to seal them, but also puff out my cheeks because at some point that is what the tape will have to seal.  I apply the tape so that its upper edge just covers the top of the upper lips, leaving the bulk of the tape to cover the lips and below the lower ones.  So, the tape's upper edge is about 1/8" above the rim of the upper lips, while the lower edge would, in my case, stick about 1/4" below the rim of my lower lips.  This might sound complicated, but it's what works, and it's automatic.

Now, an important step;  press the entire surface of the tape firmly.  Go over it again.  Now, with any luck, this tape will provide a good and reliable seal until you remove it.  Remember which side the tab is on.

Apart from the tab tip, you had best experiment over the next few days.  Shorter is not going to be better, so don't cheap out on the tape.  It must extend for almost half an inch beyond the edges of the lips.
Post Reply Post Reply
#16
RE: Masks, mouth-breathing
(02-26-2019, 06:06 PM)Dyssomniac Wrote: ...Is the usual thing to cut the tape pretty short just to cover the lip area? I was using ~7" long strips of Micropore tape, on the theory that I wanted to make sure the mouth stayed closed. (Or maybe I've watched too many movies where kidnap victims get their mouths taped shut.) Maybe I should keep the tape shorter...

We might find it differently, but I will explain my method and what has been reliable for me:

I tear off enough that both ends extend approximately 1/2" past either corner of my mouth.  

However, I fold over one end so that there is a non-stuck tab approximately 1/8" which I can easily take hold of and use to peel the tape off.  I found this handy trick the hard way; I awoke only once to find both nostrils stuffed up and me clawing at my face.  The next night, I had a tab in place.   Don't worry, this has yet to be repeated...it seems to be a rare experience.

So, firstly, I make sure my mouth surface is clean.  No oils, food, schmutz...whatever, and in my case that my face is clean-shaven, or nearly so.

I purse my lips somewhat to seal them, but also puff out my cheeks because at some point that is what the tape will have to seal.  I apply the tape so that its upper edge just covers the top of the upper lips, leaving the bulk of the tape to cover the lips and below the lower ones.  So, the tape's upper edge is about 1/8" above the rim of the upper lips, while the lower edge would, in my case, stick about 1/4" below the rim of my lower lips.  This might sound complicated, but it's what works, and it's automatic.

Now, an important step;  press the entire surface of the tape firmly.  Go over it again.  Now, with any luck, this tape will provide a good and reliable seal until you remove it.  Remember which side the tab is on.

Apart from the tab tip, you had best experiment over the next few days.  Shorter is not going to be better, so don't cheap out on the tape.  It must extend for almost half an inch beyond the edges of the lips.
Post Reply Post Reply


Possibly Related Threads...
Thread Author Replies Views Last Post
  Full Mask makes nasal breathing difficult? Diotima245 10 131 Yesterday, 08:09 PM
Last Post: Diotima245
  How Can I solve dry mouth? jeffng 3 106 Yesterday, 01:05 AM
Last Post: crowtor
  Dry mouth Lee Rilea 8 291 05-16-2019, 08:25 PM
Last Post: midastouch
Question [CPAP] Suggestions & strange breathing Mike54 16 391 05-15-2019, 02:46 AM
Last Post: Mike54
Gross [Symptoms] Unusual breathing patterns sw33ttsunade 0 125 05-13-2019, 07:20 PM
Last Post: sw33ttsunade
  Mouth Breathing and type of mask Cloudboy 4 279 04-26-2019, 07:43 AM
Last Post: Cloudboy
  [Pressure] No air forced out with mouth open dragonflyoh 6 344 04-24-2019, 01:08 PM
Last Post: sheepless


New Posts   Today's Posts






About Apnea Board

Apnea Board is an educational web site designed to empower Sleep Apnea patients.