PRS1 + Oxy import problem: bug or PEBKAC?
Hi,
My partner has finally managed to persuade the hospital to give her an APAP machine on a permanent basis — a brand new PRS1 S60 Auto, model 561P, looks like manufactured July 2016, just in case it's relevant. (She was started on an APAP, same model, for 2 weeks to get the 90th %ile pressure and was then put on a crappy ResMed S9 Escape, so no data
Worse, it's clear her needs vary from night to night, and she couldn't tolerate more than a constant 8 cm without waking up dizzy and with leg cramps, even though she needs up to 12–13 cm at times.)
The data from the trial 2 weeks were all imported into SH 0.9.8, and we've since upgraded to 1.0.0ß2 cb213cc. We now seem to have a problem that is either a bug or case of PEBKAC (Problem Exists Between Keyboard And Chair). If it's a bug, I'll report it in the appropriate thread, but I'd like to confirm that it really is a bug first.
When the APAP data are first imported (direct from SD):
After importing oximetry (CMS50E) from a .spoR file (not downloaded directly, because sometimes the download is broken):
Rebuilding PAP data doesn't make any difference, but purging that day's data and rebuilding PAP data to re-import from the local backup sets everything right again but, obviously, without oximetry.
Is the problem with me, my data or SleepyHead?
Thanks,
My partner has finally managed to persuade the hospital to give her an APAP machine on a permanent basis — a brand new PRS1 S60 Auto, model 561P, looks like manufactured July 2016, just in case it's relevant. (She was started on an APAP, same model, for 2 weeks to get the 90th %ile pressure and was then put on a crappy ResMed S9 Escape, so no data
Worse, it's clear her needs vary from night to night, and she couldn't tolerate more than a constant 8 cm without waking up dizzy and with leg cramps, even though she needs up to 12–13 cm at times.)The data from the trial 2 weeks were all imported into SH 0.9.8, and we've since upgraded to 1.0.0ß2 cb213cc. We now seem to have a problem that is either a bug or case of PEBKAC (Problem Exists Between Keyboard And Chair). If it's a bug, I'll report it in the appropriate thread, but I'd like to confirm that it really is a bug first.
When the APAP data are first imported (direct from SD):
- the session summary in the daily view correctly reports machine and configuration, including "PAP mode: APAP (Variable)",
- machine settings incorrectly reports that the humidifier was connected (no biggie, I guess), and
- the overview pressure plot shows bars as expected (although the maximum reported is the set maximum, not the recorded maximum — which might be a bug in its own right, but at least it's consistent with previous behaviour).
After importing oximetry (CMS50E) from a .spoR file (not downloaded directly, because sometimes the download is broken):
- the session summary in the daily view now reports "PAP mode: CPAP" and yet it still reports the correct programmed min/max pressures, and
- the overview pressure plot bars are gone. The median and 90%ile figures are gone from the tool-tip which, instead, shows a constant pressure of something like -34028234663852885981170483484516925440.00
Rebuilding PAP data doesn't make any difference, but purging that day's data and rebuilding PAP data to re-import from the local backup sets everything right again but, obviously, without oximetry.
Is the problem with me, my data or SleepyHead?
Thanks,
David.
