Hello Guest, Welcome to Apnea Board !
As a guest, you are limited to certain areas of the board and there are some features you can't use.
To post a message, you must create a free account using a valid email address.

or Create an Account


New Posts   Today's Posts

[Equipment] S9 info
#11
RE: S9 info
(11-15-2014, 03:16 PM)Shamus54 Wrote: Hours showed 7.8 for sleep time this morning, and 10 for total run time, (which is a little strange lol). Thanks for the replies and welcome!

There is a 20 minute cool down cycle after you stop therapy (if press power button briefly and don't hold down power button for 3 or 4 seconds to Power Off the machine).

With the S9 AutoSet, I think, if before you start therapy you hold down the round dial for 3 seconds it will start the pre-heat cycle. If you start the pre-heat cycle and don't start therapy within 20 minutes, a 20 minute cool-down cycle will follow. I suppose the A10 AutoSet would be similar. All these extra minutes would be included in total run time.

The Advisory Member group provides advice and suggestions to Apnea Board administrators and staff on matters concerning Apnea Board operation and administrative policies.  Membership in the Advisory Member group should not be understood as in any way implying medical expertise or qualification for advising Sleep Apnea patients concerning their treatment.
Post Reply Post Reply
#12
RE: S9 info
On the S9:

"Used hours" goes to zero if you use the "erase data" function.

"Run hours" accumulates from when the machine was built and can't be reset.

Run hours is the one you want to look at to see if it's a used machine.
Get the free OSCAR CPAP software here.
Useful links.
Click here for information on the main alternative to CPAP.
If it's midnight and a DME tells you it's dark outside, go and check it yourself.
Post Reply Post Reply
#13
RE: S9 info
Pretty much got the controls and menu down now, but the verdicts still out as to sleep results... Third night was a little rough with an over pressure event which woke me up. I was on my left side, and the pressure was probably maxed out at 20 by the feel of it? I may switch it back to the CPAP mode if that continues...
Post Reply Post Reply


Possibly Related Threads...
Thread Author Replies Views Last Post
  Please, need help reading the leak rate and LL info chronic 4 132 03-18-2024, 08:05 AM
Last Post: chronic
  Resvent iBreeze APAP and BiPAP info TechieHippie 2 261 02-04-2024, 03:11 PM
Last Post: TechieHippie
  Do Doctors Even Have Access to Flow Limits Info? paulag1955 16 693 01-17-2024, 03:11 PM
Last Post: dataq1
  DreamStation Go Recall [consolidated replacement & compensation info & questions] PHXSleeper 127 19,642 12-17-2023, 06:31 AM
Last Post: Tampa Jim
Question Please Review My Data (Oximeter Info Included) — Still Tired Despite "Good" Treatment avhenry 16 1,984 12-04-2023, 01:10 PM
Last Post: Dormeo
  Resvent iBreeze 20A - any info? BadGoodDeb 7 1,570 06-27-2023, 11:34 PM
Last Post: Crimson Nape
  What info about you in on the SD card? Rockandroll 1 424 06-05-2023, 10:20 PM
Last Post: Gideon


New Posts   Today's Posts


About Apnea Board

Apnea Board is an educational web site designed to empower Sleep Apnea patients.