(12-15-2014, 04:11 PM)Phil Wrote: Last week I bought a new CPAP Airsense 10 AutoSet . After two days of use, the machine stopped working and it showed Error code 006. Does anyone know what this means?
Hi Phil, welcome to Apnea Board!
From the AirSense 10 User Guide (not the clinician set-up manual):
System fault, refer to user guide, Error 004
1. Device may have been left in a hot environment. Allow to cool before re-use. Disconnect the power supply and then reconnect it to restart the device.
2. Air filter may be blocked. Check the air filter and replace it if there are any blockages.
3. Disconnect the power supply and then reconnect it to restart the device.
4. Air tubing may be blocked. Check the air tubing and remove any blockages. Press the dial to clear the message and then press Start/Stop to restart the device.
5. There may be water in the air tubing. Empty the water from the air tubing. Disconnect the power supply and then reconnect it to restart the device.
All other error messages, for example, System fault, refer to user guide, Error 0XX
An unrecoverable error has occurred on the device. Contact your care provider. Do not open the device.
The Advisory Member group provides advice and suggestions to Apnea Board administrators and staff on matters concerning Apnea Board operation and administrative policies. Membership in the Advisory Member group should not be understood as in any way implying medical expertise or qualification for advising Sleep Apnea patients concerning their treatment.