Resmed S10 auto settings

[JEDP]

I think I may have an error in my settings. I have UARS and set it to 8 for min and max pressure because I thought I might be less bothered by consistent pressure. My issue though is that I have EPR set at 2 but when I looked at my Oscar data it does not look like EPR is functioning. Also, I have a lot of flow limitations, so I think EPR may be beneficial. How can I fix it? It does say EPR 2 in my clinical menu. 

This image is from last night, which is better data than I have had for the past couple of months.  

Thanks!

[OpalRose]

Yes, EPR is set at 2.  
Your pressure at 8 minus 2 EPR = EPAP of 6.  

EPAP shows in the left sidebar under statistics.
EPAP 6 also shows in your pressure graph as a green line (at the bottom).  It's not too visible, but it is there.  

If you want to experiment, you can move EPR to 3 to clean up Flow Limitation, but in return, you may see Obstructives or CA's.  Try it and observe, you can always change it back.  

Your chart looks very good though, so it's up to you.