Hello Guest, Welcome to Apnea Board !
As a guest, you are limited to certain areas of the board and there are some features you can't use.
To post a message, you must create a free account using a valid email address.

or Create an Account


New Posts   Today's Posts

Leaving your FF mask a little loose-does it work for you?
#11
RE: Leaving your FF mask a little loose-does it work for you?
Hi PaBlum, someone in another thread made a comment that witch hazel is bad for mask cushions. Just throwing it out there.
Post Reply Post Reply
#12
RE: Leaving your FF mask a little loose-does it work for you?
Hi PaBlum,
WELCOME! to the forum.!
I would think, if you wrince your face well before you mask up, the witch hazel shouldn't hurt the cushion.
Best of luck with your new S9.
trish6hundred
Post Reply Post Reply
#13
RE: Leaving your FF mask a little loose-does it work for you?
I've been giving some thought to using witch hazel since I use it 2-3 times a week with no problems. Witch Hazel is a solution which (no pun) contains alcohol. So, the alcohol part is definitely bad for cushions even if no other part is. So why don't I have problems? Because I don't use the witch hazel on my mask, but on my face. And I towel it off immediately. Since it is alcohol based, whatever isn't removed by the towel evaporates almost instantly.

Paul

PS: I use it every morning after shaving as a lightweight aftershave/cleanser.
Post Reply Post Reply
#14
RE: Leaving your FF mask a little loose-does it work for you?
(08-09-2013, 04:20 PM)RonWessels Wrote: Well, you are running some rather higher-than-average pressures, and from personal experience I know that keeping mask leaks under control at those higher pressures is a close balancing act.

I forget if it was you in another thread, but one thing that does help me keep a good seal is to wash the mask cushion and flap as well as washing your face right before bed. Before too many nights, skin oil makes keeping a seal harder and harder for me.

Does your mask have a flap as well as a cushion? The flap is sort of like a hovercraft skirt, and helps create the seal when it inflates. It should smooth out any places where the mask cushion does not exactly match the contour of your face. If all you have is a cushion, then you are going to have to make sure that there is contact with your skin along the entire perimeter of the mask.

Have u tried mask liners like Remzzzs
Post Reply Post Reply


Possibly Related Threads...
Thread Author Replies Views Last Post
  Tech Nerds-think this battery setup will work for Transcend Micro? johnbrain 10 309 04-02-2024, 11:43 PM
Last Post: johnbrain
  Lowenstein Prisma 20A - how can I work out energy usage for camping? JamesD0079 4 709 02-15-2024, 04:16 PM
Last Post: JamesD0079
  Finally found through DISE why cpap/bipap/ASV was never going to work for me. logart89 9 1,434 08-01-2023, 09:36 AM
Last Post: logart89
  Travel PAP machines - heat/moisture exchange units - do they work? Bostonsnow 1 793 06-10-2023, 06:34 AM
Last Post: cate1898
  RESMED S9 Smart Stop does not work Taxifahrt 20 13,426 05-14-2023, 02:34 AM
Last Post: Patt1
  High AHI, Extreme Fatigue, Cannot get CPAP or BiPap to work exchanged 2 628 04-28-2023, 06:38 PM
Last Post: exchanged
  [Diagnosis] Can Cpap "work" but still be useless in treating symptoms? tom41 13 1,129 04-25-2023, 11:29 AM
Last Post: Sleeprider


New Posts   Today's Posts


About Apnea Board

Apnea Board is an educational web site designed to empower Sleep Apnea patients.