Hello Guest, Welcome to Apnea Board !
As a guest, you are limited to certain areas of the board and there are some features you can't use.
To post a message, you must create a free account using a valid email address.

or Create an Account


New Posts   Today's Posts

pulled the cpap off the dresser and onto my head
#41
Buy 3M command Cord Bundler -2 pack from Amazon. Use them both to tether the hose on the wall, near the machine end. Make sure that on the machine end, the hose is initially routed more vertically than horizontally (its harder to pull the machine off the dresser than to drag it across). You may use more of the same to route it over your head in your sleeping position.
Started APAP 4-20, Closed range to 7.5-14, then straight 8.0 w/ Aflex 3
RDI always below 1. But sleep much much better at straight pressure.
Started on F10, Tried Quattro Air successfully. Finally settled on P10.
Post Reply Post Reply
#42
(02-13-2015, 02:30 PM)quiescence at last Wrote: Ghost is most definitely an engineer. I recognize the tools of the trade, including the engineering tape. At least that's what we call it.

Wished I was QAl. But alas Im not. A disabled over the road trucker and heavy equipment operator for the most part.

But back in the day of the older road rigs, zip ties, duct tape, velcro and a pair of vice grips has gotten me home many times vs sitting beside the road 1000 miles from home . Same with my motorcycles Grin



Post Reply Post Reply
#43
(02-10-2015, 09:24 PM)Mike1953 Wrote: and a box of extra clips

They are called magazines. "Clips" only apply to the en-bloc 8 round clip for the M1 Garand Rifle and stripper clips used to charge some military arms such as the Enfield No4 or the Springfield M1903.

(02-14-2015, 01:09 AM)Ghost1958 Wrote:
(02-13-2015, 02:30 PM)quiescence at last Wrote: Ghost is most definitely an engineer. I recognize the tools of the trade, including the engineering tape. At least that's what we call it.

Wished I was QAl. But alas Im not. A disabled over the road trucker and heavy equipment operator for the most part.

But back in the day of the older road rigs, zip ties, duct tape, velcro and a pair of vice grips has gotten me home many times vs sitting beside the road 1000 miles from home . Same with my motorcycles Grin

In Mississippi they use a large C-clamp; and just clamp the PAP to a cable reel that's used as a nightstand.Dielaughing
INFORMATION ON APNEA BOARD FORUMS OR ON APNEABOARD.COM SHOULD NOT BE CONSIDERED AS MEDICAL ADVICE. ALWAYS SEEK THE ADVICE OF A PHYSICIAN BEFORE SEEKING TREATMENT FOR MEDICAL CONDITIONS, INCLUDING SLEEP APNEA. INFORMATION POSTED ON THE APNEA BOARD WEB SITE AND FORUMS ARE PERSONAL OPINION ONLY AND NOT NECESSARILY A STATEMENT OF FACT.
Post Reply Post Reply


#44
(02-13-2015, 02:30 PM)quiescence at last Wrote: Ghost is most definitely an engineer. I recognize the tools of the trade, including the engineering tape. At least that's what we call it.

Many folk who have a fantasy playroom in their home should have the same gear Whistle

Post Reply Post Reply
#45
I did it too
I did it too. A couple of years ago. Got a pair of adjustable 1/4 x 24 or 30" bungee cords at Home Depot or Lowes. Travel every where. Never found a hotel night stand where I couldn't adjust them to fit. Get big plastic hooks on the end. They will hook under the edges of most nightstands, otherwise you can make one cord out of two and wrap it around the entire night stand. Add a two inch wide Velcro patch stuck to the top of the unit and place a cord between the Velcro pieces and it is rock solid -- can't slip off. This sounds complicated but it is easier done than said. I would not like to damage the furniture finish with duck tape, but then I never even thought of that.
Post Reply Post Reply
#46
"They are called magazines. "Clips" only apply to the en-bloc 8 round clip for the M1 Garand Rifle and stripper clips used to charge some military arms such as the Enfield No4 or the Springfield M1903."

^^This! You can call 'em what you want, but they are mags!
Post Reply Post Reply


#47
I realize this thread is a month old, but I laughed. I pulled my machine off the night table the other night while sleeping. Just rolled over, and then rolled again. I'm not sure who was more shaken, the husband from the noise, or the dog it landed on. They both gave me the same accusatory look, followed by an exasperated eyeroll.

Post Reply Post Reply
#48
I ended up with one of those $7 hose poles that seats in the mattress. It is between the cpap and the bed and keeps the cpap from scooting off the table Big Grin
هههههه هههههه هههههه هههههه هههههه هههههه هههههه هههههه هههههه هههههه هههههه هههههه هههههه هههههه
Tongue Suck Technique for prevention of mouth breathing:
  • Place your tongue behind your front teeth on the roof of your mouth
  • let your tongue fill the space between the upper molars
  • gently suck to form a light vacuum
Practising during the day can help you to keep it at night

هههههه هههههه هههههه هههههه هههههه هههههه هههههه هههههه هههههه هههههه هههههه هههههه هههههه هههههه
Post Reply Post Reply
#49
(03-13-2015, 10:06 AM)DariaVader Wrote: I ended up with one of those $7 hose poles that seats in the mattress. It is between the cpap and the bed and keeps the cpap from scooting off the table Big Grin

That's what I use and my cpap hasn't budged on the nightstand.
Post Reply Post Reply


#50
(03-13-2015, 10:06 AM)DariaVader Wrote: I ended up with one of those $7 hose poles that seats in the mattress. It is between the cpap and the bed and keeps the cpap from scooting off the table Big Grin

Those darned CPAPs they scoot all over the place unless you tether them. Maybe you should quit feeding your CPAP all of those vitamins. Dont-know Oh-jeez Dielaughing

Best Regards,

PaytonA
Post Reply Post Reply


Possibly Related Threads...
Thread Author Replies Views Last Post
  Head Cold from CPAP? vailgal 6 203 08-08-2017, 09:39 AM
Last Post: Mosquitobait
  Calendar issues and Sleepy Head mraroid 4 200 08-02-2017, 01:03 PM
Last Post: mraroid
  My AHI numbers are high (Sleepy Head) mraroid 36 974 08-01-2017, 09:23 AM
Last Post: mraroid
  [CPAP] New ResMed F20 head gear issues Tballinusa9 11 1,135 06-27-2017, 01:39 PM
Last Post: Grmato10
  Typical Night - Sleepy Head Screen BrassCat 16 543 05-29-2017, 12:48 PM
Last Post: bonjour
Gross Sleepy Head from Last Night aeilers 6 264 05-17-2017, 01:41 PM
Last Post: aeilers
  Okay to use old head-gear, pillows, with new machine? Agabaga 4 244 05-01-2017, 06:40 AM
Last Post: Melman

Forum Jump:

New Posts   Today's Posts




About Apnea Board

Apnea Board is an educational web site designed to empower Sleep Apnea patients.

For any more information, please use our contact form.