(11-28-2015, 06:35 PM)bwexler Wrote: The only way to know if your pressure is set correctly is by using software to monitor your events.
It looks like you might want to go into your profile and identify your machine in the correct location, add your mask, then download and install Sleepyhead software and add that to your profile.

If you have the airsense 10 for her, why do you have it set at a fixed pressure of 7.6 instead of a range (perhaps 6-10).

Raising the head of your bed is supposed to help several medical conditions, especially if you sleep on your back.

(11-28-2015, 06:48 PM)Barbz Wrote: I have to sleep on my back, lumbar trauma, and that meant higher pressures. Did not want higher pressures! Using SleepyHead I monitored my pressure as I raised the head of my bed.

First I had a wedge and added pillows. I now have an adjustable bed. Not long ago I did a test...lowered the HOB and looked at numbers...lousy! Back up it went.

(11-28-2015, 07:09 PM)cate1898 Wrote: I'll mention this again. If you take out the SD card and switch the little white tab down to the locked position you can then put it in your computer and download the data. Won't affect anything. My doc is looking at my data that's being recorded now and I do this every morning. Download and install SH and then look at your data to see what is going on.

Oh and don't forget to unlock the SD card before you put it back into the A10.

(11-28-2015, 07:09 PM)cate1898 Wrote: I'll mention this again. If you take out the SD card and switch the little white tab down to the locked position you can then put it in your computer and download the data. Won't affect anything. My doc is looking at my data that's being recorded now and I do this every morning. Download and install SH and then look at your data to see what is going on.

Oh and don't forget to unlock the SD card before you put it back into the A10.

(11-29-2015, 09:08 AM)OpalRose Wrote: I also use an adjustable bed. I mostly sleep on either side, but the adjustable bed, enables me to sleep on my back without my pressure going up. If I put the bed in a flat position and try to sleep on my back, pressure goes up because there are more apneas to take care of!

To answer OP's question. I don't know if she would be able to lower pressure with the head of bed elevated. She is on a straight pressure setting, and she has not told us her AHI or breakdown of AHI.

linn, you need to start tracking your data, loaner machine or not.

I check my numbers a couple times a week. Even though I sleep elevated, my pressure needs stay the same, and I don't experience much higher AHI numbers. Usually under 1.