+- Apnea Board Forum - CPAP | Sleep Apnea (https://www.apneaboard.com/forums)
+-- Forum: Public Area (https://www.apneaboard.com/forums/Forum-Public-Area)
+--- Forum: Main Apnea Board Forum (https://www.apneaboard.com/forums/Forum-Main-Apnea-Board-Forum)
+--- Thread: Difference between ResMed AirCurve & AirSense (/Thread-Difference-between-ResMed-AirCurve-AirSense)
Pages:
1
2
Difference between ResMed AirCurve & AirSense - BandMom - 11-30-2015
I need help. Have been using CPAP for about 14 years. Currently using Fisher & Paykel SleepStyle 200. Machine is at least 8 years old. This machine gives you no information at all. The only feedback on my sleep is from my husband telling me that I'm snoring, my mask slipped, or I have a mouth leak. Can't wait to use SleepyHead! Tried to switch machines a couple of times, but they were always noisier than this one. F & P Icon is last one I tried. There was a whistle that bothered my husband. I hated the constant up and down wheezing noise with every breath.
I have a Rx order for Auto CPAP. From your wonderful review page, I'm deciding between the ResMed AirCurve 10 Vauto and the ResMed AirSense 10 Auto (maybe for Her). I can't seem to figure out the difference between the AirSense vs. AirCurve; and Auto vs. Vauto.
Any advice you can offer will be greatly appreciated. Looking forward to getting a new machine, but don't want to buy the wrong one. Insurance company requires rental for first few months (I suppose to make sure it works for you).
RE: Difference between ResMed AirCurve & AirSense - justMongo - 11-30-2015
Vauto is an auto bilevel machine. Sometimes called a BiPAP.
The Airsense 10 Autoset is an Auto adjusting machine... quite popular.
The Aircurve 10 Vauto is quite similar but permits a wider split between inhalation and exhalation pressures. (bilevel)
Bilevel is often used at higher pressures where people need more expiratory relief than the EPR setting on the non-bilevel machine can be set to.
I think that "technically" your Rx, as stated, limits you to the Airsense 10 Autoset as the word bilevel would need to be in the Rx for a provider to dispense a Aircurve 10 Vauto.
RE: Difference between ResMed AirCurve & AirSense - zonk - 11-30-2015
(11-30-2015, 03:56 PM)BandMom Wrote: I have a Rx order for Auto CPAP. From your wonderful review page, I'm deciding between the ResMed AirCurve 10 Vauto and the ResMed AirSense 10 Auto (maybe for Her). I can't seem to figure out the difference between the AirSense vs. AirCurve; and Auto vs. Vauto.If we're dealing with obstructive apnea (not central or mixed) then the AutoSet is all what you need given that your CPAP pressure 11/2 is not in the top end. Why use a sledge hammer to crack a walnut
RE: Difference between ResMed AirCurve & AirSense - BandMom - 11-30-2015
Thank you zonk and justMongo! Very helpful information. Since all I have ever used is traditional CPAP, with no pressure changes for inhalation and exhalation, I assume that I'll be fine with the AirSense Auto 10.
Will the software already built into machine be helpful to layperson? Any idea how long it will be until SleepyHead has program for this machine?
RE: Difference between ResMed AirCurve & AirSense - OpalRose - 11-30-2015
(11-30-2015, 06:16 PM)BandMom Wrote: Thank you zonk and justMongo! Very helpful information. Since all I have ever used is traditional CPAP, with no pressure changes for inhalation and exhalation, I assume that I'll be fine with the AirSense Auto 10.
Will the software already built into machine be helpful to layperson? Any idea how long it will be until SleepyHead has program for this machine?
Sleepyhead already supports the AirSense 10 Auto.
RE: Difference between ResMed AirCurve & AirSense - BandMom - 11-30-2015
Thanks Opal Rose!
RE: Difference between ResMed AirCurve & AirSense - trish6hundred - 12-01-2015
Hi BandMom,
WELCOME! to the forum.!
good luck to you on your machine decision and much success to you as you continue your CPAP therapy.
RE: Difference between ResMed AirCurve & AirSense - BandMom - 12-01-2015
I wish I would have found this forum years ago! Everyone has been so welcoming and helpful. After checking local sources for the AirSense 10, my only option is to use Apria if I want that machine. I've been down that road before and won't do it again. My next best source is attached to my sleep doctor's office. The only machine they carry is the Philips Respironics Dream Station. I know it is very new, but reading different posts on this site, I'm hoping it is a good machine. That office does have a variety of masks, so maybe they will have what I want to try (Dream Wear nasal mask). I need a mask that I can wear sleeping on my side or stomach. I'm not able to sleep on my back due to stenosis in my neck.
Thanks again for the warm welcome everybody!
RE: Difference between ResMed AirCurve & AirSense - SaldusMiegas - 12-02-2015
Hi BandMom and welcome to the forum.
I'm wondering why the insurance would require a trial rental period on a replacement machine. It's not like they don't know if CPAP therapy will be effective since you have been successfully using it for many years. Might be worth checking if you have not already asked your insurance company about this. They might have a different (less profitable) answer than the DME provides regarding rental periods. Perhaps you can skip the rental period on a replacement machine.
best wishes,
Saldus Miegas
RE: Difference between ResMed AirCurve & AirSense - archangle - 12-02-2015
You might want to ask the other DME if they'll order an Airsense for you or even if they still have any PRS1 (System one) Auto machines.
The DreamStation is probably good, but SleepyHead and even Encore software aren't available to us yet. The only software available is the online cell modem stuff, and it's enormously inferior to Encore Basic or SleepyHead.
I don't have a lot of confidence SleepyHead or Encore will get updated soon, and you need good data when you start your therapy.