+- Apnea Board Forum - CPAP | Sleep Apnea (https://www.apneaboard.com/forums)
+-- Forum: Public Area (https://www.apneaboard.com/forums/Forum-Public-Area)
+--- Forum: Main Apnea Board Forum (https://www.apneaboard.com/forums/Forum-Main-Apnea-Board-Forum)
+--- Thread: What or which is my machine (/Thread-What-or-which-is-my-machine)
What or which is my machine - Scrapjockey - 04-26-2016
I am attempting to change the air flow/pressure setting on my CPAP, but am having problems identifying my machine. I apologize if this has been run into the ground on previous postings, but I am new and altho I have searched, I have not been able to find a previous thread regarding this issue. Anyway, the "REF" on the bottom of my machine is 460P REMster Pro, DOM. I am unable to match this with the machines listed in the instructions for changing pressure/air flow. Can, or will, someone assist me? Again, I apologize if this has been dealt with in the past. BTW, is there a search window anywhere on the forum site?
I found the search window when I scrolled down to "post".
RE: What or which is my machine - OpalRose - 04-26-2016
You have a Phillips Respironics 60 Series RemStar Pro.
Order the Clinicians Manual here:
http://www.apneaboard.com/adjust-cpap-pressure/change-cpap-pressure-settings-adjusting-your-machine-with-a-clinician-setup-manual
In the meantime, you can access the providers menu by highlighting setup on the screen, then hold down the round knob and the small arrow key at the same time until you hear a double beep.
Now you will be able to make the pressure change.
RE: What or which is my machine - Scrapjockey - 04-26-2016
Thank you OpalRose. Unfortunately, when I highlite the "setup" and then hold the round knob and arrow key at the same time, it moves to "exit" after one beep. I am going to now, since you ID'd my machine, going to try the method described on the website, unless you can see where I am going wrong with your suggestion.
Scrapjockey
OpalRose, I got it. What I did not notice when following your instructions was that the screen changed. I did not hear any beeps. You were exactly correct in your instructions, I as usual, was dense. Thank you again.
Scrapjockey
RE: What or which is my machine - OpalRose - 04-26-2016
Glad it worked. I have the 560 series, and I was assuming the 460 worked the same.
RE: What or which is my machine - trish6hundred - 04-26-2016
Hi Scrapjockey,
WELCOME! to the forum.!
Much success to you with your CPAP therapy and hang in there for more responses to your post.
RE: What or which is my machine - tomurphy - 08-25-2016
Scrapjocky: You are right. I have the same machine, with the exact information on the sticker that you do. I also can not find any information on how the change the pressure settings. I can push the main button and the ramp button, get two beeps and see a new screen. But non of the available selections look like they change the pressure. I have search everywhere.
RE: What or which is my machine - JWR - 08-25-2016
Rotate the knob till control knob till setup shows, then press the control knob and ramp till it beeps then rotate the control knob back to setup and press only the control knob once then your in the main settings. Down load a clinicians manual at the top of Apneaboard main page for PS460 it will help you figure out the settings.