SleepyHead not showing leak data - Printable Version +- Apnea Board Forum - CPAP | Sleep Apnea (https://www.apneaboard.com/forums) +-- Forum: Public Area (https://www.apneaboard.com/forums/Forum-Public-Area) +--- Forum: Software Support Forum (https://www.apneaboard.com/forums/Forum-Software-Support-Forum) +--- Thread: SleepyHead not showing leak data (/Thread-SleepyHead-not-showing-leak-data) |
SleepyHead not showing leak data - rem52 - 05-16-2016 I have a ResMed A10 CPAP brick, which I am trying to change... In comparing ResScan 5.5.0.9xxx and SleepyHead v0.9.8-1 data, I can see where ResScan is showing leak data from 0 to 39.6. However SleepyHead is not showing any leak data at all. Is this a feature due to the brick value of my machine or a bug? RE: SleepyHead not showing leak data - AlanE - 05-16-2016 It's possible Sleepyhead won't read the data properly because of the machine. I also wouldn't rule out a bug. Which version of Sleepyhead are you using? RE: SleepyHead not showing leak data - rem52 - 05-17-2016 SleepyHead v0.9.8-1 RE: SleepyHead not showing leak data - AlanE - 05-17-2016 My bad, you *did* say what version SH you were using in your first message. I wouldn't have much hope of trying to get SH to work with your machine. The importer for it was (most likely) not done because it is a brick. I would stick with ResScan until you change out the machine. ResScan is still very useful. In my opinion, for what that is worth. RE: SleepyHead not showing leak data - rem52 - 05-18-2016 ok thanks |