PRS1+FlashAir W-03 Recording only 7 minutes of waveform data - Printable Version +- Apnea Board Forum - CPAP | Sleep Apnea (https://www.apneaboard.com/forums) +-- Forum: Public Area (https://www.apneaboard.com/forums/Forum-Public-Area) +--- Forum: Software Support Forum (https://www.apneaboard.com/forums/Forum-Software-Support-Forum) +--- Thread: PRS1+FlashAir W-03 Recording only 7 minutes of waveform data (/Thread-PRS1-FlashAir-W-03-Recording-only-7-minutes-of-waveform-data) |
PRS1+FlashAir W-03 Recording only 7 minutes of waveform data - cntrlwiz - 04-23-2017 I managed to properly set up my PRS1 with a FlashAir card, and I can pull data with FlashPAP. However, the machine is now only recording about 7 minutes of waveform data with every session. If I pull the card and read it with my PC, the data is not there...so it isn't a transfer issue. Any suggestions? RE: PRS1+FlashAir W-03 Recording only 7 minutes of waveform data - cntrlwiz - 04-23-2017 Here's my FlashAir CONFIG file: #Thu Apr 20 22:24:16 EDT 2017 DNSMODE=0 APPMODE=5 CID=<redacted> NOISE_CANCEL=0 APPNETWORKKEY=********** PRODUCT=FlashAir APPNAME=PRS1 APPSSID=<redacted> LOCK=1 APPAUTOTIME=0 VENDOR=TOSHIBA CIPATH=/DCIM/100__TSB/FA000001.JPG VERSION=FA9CAW3AW3.00.01 RE: PRS1+FlashAir W-03 Recording only 7 minutes of waveform data - Crimson Nape - 04-23-2017 Hi cntrlwiz - Welcome to the forum! Were you using a regular SD card prior to the FlashAir? If so, was it storing a complete night's worth of data? The only other thing that comes to mind would be to insert the FlashAir into your computer and perform a disk check. Being new, it could just be a bad card. RE: PRS1+FlashAir W-03 Recording only 7 minutes of waveform data - cntrlwiz - 04-23-2017 The original SD card works fine. The FA card is brand new, so I hope it doesn't have issues. RE: PRS1+FlashAir W-03 Recording only 7 minutes of waveform data - cntrlwiz - 04-27-2017 SOLVED -- I figured this out. I am using a 16GB FlashAir W-03 SD card. My PRS1 was put into service in July 2012, and it has 905 firmware. For whatever reason, it can't tolerate the 16GB SD card. So, I reformatted the card as a 2GB card, and it works fine. That means I have "only" 2GB of space for data, but almost 5 years of data is only taking up about 180mb. I think I'll survive. RE: PRS1+FlashAir W-03 Recording only 7 minutes of waveform data - cntrlwiz - 05-01-2017 NOT SOLVED... It worked ok for 1 night, then it's back to only capturing a little bit (5-10 minutes) of waveform data at the beginning of a session. Back to the drawing board... I guess the next thing is to try a different card. |