+- Apnea Board Forum - CPAP | Sleep Apnea (https://www.apneaboard.com/forums)
+-- Forum: Public Area (https://www.apneaboard.com/forums/Forum-Public-Area)
+--- Forum: Main Apnea Board Forum (https://www.apneaboard.com/forums/Forum-Main-Apnea-Board-Forum)
+--- Thread: [Equipment] Resmed S10 Sleep Report Reset ?? (/Thread-Equipment-Resmed-S10-Sleep-Report-Reset)
Resmed S10 Sleep Report Reset ?? - larry2001 - 06-08-2017
I recently went from Resmed S9 to S10. The S10 works fine but the prior nights sleep data display (AHI, hours, etc) does not "zero out" at noon as on the s9. However, the next day the correct recording of that nights data appears and is transmitted to MyAir. Despite "holding" the data all day, it does not appear to just accumulate more data as if there was no zeroing out process.
Is this normal behavior ? My supplier says it should zero out at noon, but I question this.
thanks
RE: Resmed S10 Sleep Report Reset ?? - justMongo - 06-08-2017
The internal clock is likley not set correctly. It should zero out at noon.
RE: Resmed S10 Sleep Report Reset ?? - pholynyk - 06-08-2017
Use the Clinician's menu to check the time. However, in my experience the data for the previous day is not zeroed at noon machine time, at least as far as its display is concerned. It stays on display until you start a new session. You can check this by having a short 3 to 5 minute session any time after machine noon. My A10's clock drifts slow quite badly, in my opinion, so check yours.
RE: Resmed S10 Sleep Report Reset ?? - larry2001 - 06-09-2017
Agree. I took 10 breaths at about 9pm and it reset I have not tried around noon yet
How do you access the clinician menu to see the time?
Can you change the time?
I know how to access an change the pressure. Is that the clinicians menu?
Thanks!
RE: Resmed S10 Sleep Report Reset ?? - sonicboom - 06-09-2017
Yes. Change the time in the clinicians menu.
RE: Resmed S10 Sleep Report Reset ?? - zonk - 06-10-2017
(06-09-2017, 12:37 PM)larry2001 Wrote: How do you access the clinician menu to see the time?
Scroll to ... Instructions for A10 series machines (AirSense 10 and AirCurve 10 machines)
http://www.apneaboard.com/wiki/index.php?title=Setting_the_clock
most of the times, you can make changes without any problems, but If changing the date or/time that occur in the past, the machine ask you to erase compliance data. if this is the case, keep the card and insert in the machine a new card or download the data before erasing anything, if you don't have to report compliance to insurance
RE: Resmed S10 Sleep Report Reset ?? - CB91710 - 06-10-2017
My A10 managed to get set 1 day ahead somehow. I tried to set it back, there was a warning about erasing data, but it would not allow me to set it back the full 24 hours.
Error message just said that it can't change time to "the past".
It will allow you to go back as far as noon, so in my case, before bed I set it back to noon, which moved it back about 9-10 hours, the did the same the next day which moved it back another 9 hours.
Last night I moved it back the remaining 3 hours which corrected it, and while no data was lost, both Sleepyhead and MyAir show that I slept for 13 hours Thursday.
I suppose the date could be set directly to any date if you were to execute the "Delete all data" command, but I don't know and the clinicians' manual doesn't say anything about that.
I would imagine that it would only erase data if you attempt to set it back to a time where data is already recorded.
I tried to set my last 3 hours when I got up yesterday, but it would not allow me to set the time into the past again... I had to wait until after noon.