[Equipment] REMstar error E-24 - Printable Version +- Apnea Board Forum - CPAP | Sleep Apnea (https://www.apneaboard.com/forums) +-- Forum: Public Area (https://www.apneaboard.com/forums/Forum-Public-Area) +--- Forum: Main Apnea Board Forum (https://www.apneaboard.com/forums/Forum-Main-Apnea-Board-Forum) +--- Thread: [Equipment] REMstar error E-24 (/Thread-Equipment-REMstar-error-E-24) |
REMstar error E-24 - RAN - 09-14-2012 I am a new member. What does error code E-24 mean on REMstar plus C-Flex? Unit started constant beep and registered E-24. It won't run. Unit is 8 years old. RE: REMstar error E-24 - zonk - 09-14-2012 (09-14-2012, 04:25 PM)RAN Wrote: I am a new member. What does error code E-24 mean on REMstar plus C-Flex? Unit started constant beep and registered E-24. It won't run. Unit is 8 years old.http://www.apneaboard.com/forums/Thread-CPAP-Service-Required-Error-Codes-Inner-Workings-of-a-CPAP-machine Have you tried to unplug and plug the machine Supplier #27 & #28 does CPAP repair but probably would cost more than whats worth Supplier #2 sells good reconditioned data capable machines http://www.apneaboard.com/forums/Thread-CPAP-Supplier-List RE: REMstar error E-24 - RAN - 09-14-2012 I will try taking my machine apart to see if I can do anything. RE: REMstar error E-24 - zonk - 09-14-2012 (09-14-2012, 04:56 PM)RAN Wrote: I will try taking my machine apart to see if I can do anything.I was adding couple of suggestion at the same time RE: REMstar error E-24 - PaulaO2 - 09-14-2012 http://www.apneaboard.com/wiki/index.php?title=REMstar_error_codes ERR_UNRECOGNIZED_CAL_VERSION_BY_SW Improper calibration -- Recalibrate Defective FLASH chip -- Replace Main PCA RE: REMstar error E-24 - PaulaO2 - 09-14-2012 But, really, it is time to get another machine. Supplier #2 has really good prices on 'gently used' and open box machines. RE: REMstar error E-24 - trish6hundred - 09-14-2012 Hi RAN, First of all, WELCOME! to the forum.! as far as your problem goes, what PaulaO2 said in both of her posts above.! Hope you can get your machine straightened out, or are able to get a new or gently used one. Best of luck to you. |