Couldn't breathe out in the morning? - Printable Version +- Apnea Board Forum - CPAP | Sleep Apnea (https://www.apneaboard.com/forums) +-- Forum: Public Area (https://www.apneaboard.com/forums/Forum-Public-Area) +--- Forum: Main Apnea Board Forum (https://www.apneaboard.com/forums/Forum-Main-Apnea-Board-Forum) +--- Thread: Couldn't breathe out in the morning? (/Thread-Couldn-t-breathe-out-in-the-morning) |
Couldn't breathe out in the morning? - Sleep2Snore - 11-25-2017 I couldn't breathe out in the morning through my nose, no idea why? I checked the vent holes in the Swift FX and they looked fine, I could breathe through them without any problems. The machine is not set for EPR, but then I was at 18 on the old machine and I had turned it off without any problems. The Airsense10 Autosense had risen a small amount, it had reached 12.5 but I was on 18 in old machine without any problems. It is a problem I have not come across before, the next two mornings were no problem, I have changed nothing, just checked vents were clear. It didn't mater how hard I tried to breathe out, I just couldn't do it! Very odd, I had to pinch myself to check I was not dreaming, I just couldn't understand it. I had to breath through my mouth, but when I tried to breath through my nose again I couldn't? I turned the machine off, had a look at everything and tried it again and all was fine. I was getting plenty of air in, I just could not breath it out again through my nose and I am at a loss to say why! Any ideas? Anyone? Not that it worries me, as I can breathe through my mouth, but I sure would like to know if anyone has had this problem before? Bed time, it is 1:30am here, goodnight. RE: Couldn't breathe out in the morning? - HalfAsleep - 11-25-2017 Exhale can be very difficult for me, too. Sometimes, it makes me rip my mask off in the night, swallow a lot of air, or hyperventilate. I use EPR, but I don't know how to address the problem otherwise.... Hope you get some ideas here! RE: Couldn't breathe out in the morning? - Sleep2Snore - 11-26-2017 Hi Halfasleep, i have no idea what happened. It has not happened since or before. The wife said I had just had a flue injection a few days before and I have a slight clod and that my nose could have been blocked, but it wasn't as I could breathe through my nose as soon as I took my mask off. I couldn't understand it at the time and I still have no idea what could have caused it. The machine said its max pressure was only 12.5 which is a long way short of what I am used to. It was just a bit strange, the fact I have no idea what caused it is slightly worrying but as I can breathe through mu mouth it is not a problem. I am just wondering if it was me that malfunctioned or was it something to do with the equipment? Expiry Relief was supposed to be turned on on the machine, but when I checked it after I got it home I found it was only during Ramp and it was not on at any other time. As I never use Ramp, that was sort of pointless anyway. At such a low pressure I would not want to use Ramp anyway. I just wish I knew what happened, it has got me stumped! |