+- Apnea Board Forum - CPAP | Sleep Apnea (https://www.apneaboard.com/forums)
+-- Forum: Public Area (https://www.apneaboard.com/forums/Forum-Public-Area)
+--- Forum: Software Support Forum (https://www.apneaboard.com/forums/Forum-Software-Support-Forum)
+--- Thread: Dreamstation Go Firmware 1.1.2 (/Thread-Dreamstation-Go-Firmware-1-1-2)
Dreamstation Go Firmware 1.1.2 - JWTESQ - 12-19-2018
I spoke with a support rep at Philips today and was informed that firmware version 1.1.2 was released on September 25, 2018 for the Dreamstation Go. I did not see it anywhere on the Apnea Board. Does anyone have it to share? Does anyone have any comments about changes since flashing from 1.1.1 to 1.1.2?
RE: Dreamstation Go Firmware 1.1.2 - SuperSleeper - 12-19-2018
Okay, we now have the newest firmware for the DreamStation Go (version 1.1.2).
Please note: this is for the DreamStation Go machines ONLY.
Go here for more info:
http://www.apneaboard.com/forums/Thread-DreamStation-firmware-updates-Use-at-your-OWN-RISK?pid=235296#pid235296
You'll need to be logged into your Apnea Board forum account to access that link.
Let me know in this post if it goes well if you decide to upgrade your firmware.
Please remember that any firmware updates are done solely at your own risk!
Version 1.1.2 firmware supports the following:
• When available, Patient Adjustable Ramp now correctly allows the patient to adjust the Ramp Time in the My Comfort submenu.
• Updated Performance Check to include MyStart, Auto-Trial and Optional Screen Enabled information.
• Updated Japanese translations.
• Bluetooth Low Energy (BLE) connections are now available in therapy.
• Updated Finnish translation for Therapy.
• The Software Update prompt, “Would you like to upgrade software?”, will reappear after a therapy session if the prompt was visible prior to the start of the therapy session.
• The MyStart Enable setting state in the Provider Comfort Settings submenu will be restored when Opti-Start is disabled in the Provider Therapy Settings submenu.
• MyStart Enable setting is only visible in the Provider Comfort Settings submenu when Auto CPAP therapy mode is selected.