Apnea Board Forum - CPAP | Sleep Apnea
[Equipment] Tube blocked Error in Resmed Airsense 10 Autoset - Printable Version

+- Apnea Board Forum - CPAP | Sleep Apnea (https://www.apneaboard.com/forums)
+-- Forum: Public Area (https://www.apneaboard.com/forums/Forum-Public-Area)
+--- Forum: Main Apnea Board Forum (https://www.apneaboard.com/forums/Forum-Main-Apnea-Board-Forum)
+--- Thread: [Equipment] Tube blocked Error in Resmed Airsense 10 Autoset (/Thread-Equipment-Tube-blocked-Error-in-Resmed-Airsense-10-Autoset)



Tube blocked Error in Resmed Airsense 10 Autoset - ddsr - 01-20-2019

Hi,
I am getting an error of "Tubing Blocked" in Airsense 10 Autoset(Him) and the air flow stops. After clearing the error the flow generator starts again. Has anyone faced such problem in AirSense 10? What is the solution for this? 
Thanks in advance.

Regards,
DDSR


RE: Tube blocked Error in Resmed Airsense 10 Autoset - Gideon - 01-20-2019

Can you provide more info on the cause, when or anything?

Dog stepped on it,
Chew Toy for the dog,
You were holding your hand over the end of the tube.
The VENT on the mask is plugged and you were holding your breath.
Kink in hose (poor hose management).
You moved your bed and accidentally placed the foot of the bed on the hose.

Just brainstorming, looking for what could possibly stop flow.

A sensor error, while unlikely, is possible.

Fred


RE: Tube blocked Error in Resmed Airsense 10 Autoset - Sleeprider - 01-20-2019

Have you checked the filter? Is there water in the tube?


RE: Tube blocked Error in Resmed Airsense 10 Autoset - PaulaO2 - 01-20-2019

Filter.
Kink in hose.
Aliens.