[CPAP] Remstar pro2 with C flex - Printable Version +- Apnea Board Forum - CPAP | Sleep Apnea (https://www.apneaboard.com/forums) +-- Forum: Public Area (https://www.apneaboard.com/forums/Forum-Public-Area) +--- Forum: Main Apnea Board Forum (https://www.apneaboard.com/forums/Forum-Main-Apnea-Board-Forum) +--- Thread: [CPAP] Remstar pro2 with C flex (/Thread-CPAP-Remstar-pro2-with-C-flex) |
Remstar pro2 with C flex - Rob Woods - 04-20-2013 Hi all, I have Remstar pro2 with C flex. On startup it displays E 24 on the screen and I am unable to do anything with it. Buttons flash but do not respond. Any assistance would be greatly appreciated. Cheers RE: Remstar pro2 with C flex - trish6hundred - 04-20-2013 Hi Rob, WELCOME! to the forum.! Did you try unplugging it and plugging it back in and see if that changed anythihg? Hang in there and someone will have a suggestion or two. Best of luck getting your machine straightened out. RE: Remstar pro2 with C flex - Rob Woods - 04-20-2013 Thanks Trish. Yes, tried several times to no avail. Thanks for the welcome and encouraging message. Kind regards, Rob RE: Remstar pro2 with C flex - grumpycat - 04-20-2013 if you go to docstoc and search for "remstar auto c-flex pro 2 warrantypmd", you will find a service manual. Don't know if this is for the pro 2 or not, but it lists error code E24, and states that the machine has to be "recalibrated, replace main PCA." hope this helps... Jeez, had to edit this three times----guess its past my bedtime. RE: Remstar pro2 with C flex - Rob Woods - 04-21-2013 (04-20-2013, 11:23 PM)grumpycat Wrote: if you go to docstoc and search for "remstar auto c-flex pro 2 warrantypmd", you will find a service manual. Don't know if this is for the pro 2 or not, but it lists error code E24, and states that the machine has to be "recalibrated, replace main PCA." Thanks heaps, will check it out now. Hope you had a good sleep. Kind regards, Rob Thanks heaps, will check it out now. Hope you had a good sleep. Kind regards, Rob RE: Remstar pro2 with C flex - Shastzi - 04-21-2013 Hi Rob! You're in the right place! |