Apnea Board Forum - CPAP | Sleep Apnea
Sudden, erroneous, invariant, on-screen (VAuto) reports of AHI - Printable Version

+- Apnea Board Forum - CPAP | Sleep Apnea (https://www.apneaboard.com/forums)
+-- Forum: Public Area (https://www.apneaboard.com/forums/Forum-Public-Area)
+--- Forum: Software Support Forum (https://www.apneaboard.com/forums/Forum-Software-Support-Forum)
+--- Thread: Sudden, erroneous, invariant, on-screen (VAuto) reports of AHI (/Thread-Sudden-erroneous-invariant-on-screen-VAuto-reports-of-AHI)



Sudden, erroneous, invariant, on-screen (VAuto) reports of AHI - 2SleepBetta - 09-18-2022

Can anyone suggest why my VAuto's on-screen report of AHI for each session has gone awry and suggest how it might be diagnosed and corrected? I bought the machine new and, until now, it has performed flawlessly for nearly 2500 run hours. I have a back-up. It looks like I must find a repair facility, find how to get fresh firmware, or--less likely-try DIY repair if good guidance can be found. 

Of course, I could ignore the problem after monitoring a bit more, just keeping an eye on what is reported by OSCAR for a time and from time to time.

For night-before-last I noticed a third night of on-screen AHI = 0.0, which rarely happens.  I decided to check the on-screen summaries for different periods. Day, weeks, months--all periods up to a year all AHI were reported on-screen as 0.0. Last night I disconnected the power cord for a minute and plugged it back in before sleep. AHI for all periods after last night sleep were reported as 0.4 (vs. 0.48 per OSCAR). I always use Auto On and, other than quick looks at on-screen AHI and Leak I haven't been paying much attention to running OSCAR. Restful sleep and all other considerations have been fine.

Thanks to my VAuto, to early and good pressure-settings coaching from ApneaBoard members and to more than year using a block to prevent supine sleep, my AHI held to 0.2 for a year. But I decided to sleep without the block a year ago, that to enable me to roll-over without having to very nearly sit up. Without the block, AHI has risen to a still low level, <0.5, as in the picture below and I will update my sidebar-AHI to 0.5. The VAuto drove down and has kept flow limitations low with PS of only 3.4 cm., vs the 3.0 cm. EPR which did not control FL well using my AutoSet. 

[attachment=44709]