Help setting up Aircurve 10 cpap to bipap - Printable Version +- Apnea Board Forum - CPAP | Sleep Apnea (https://www.apneaboard.com/forums) +-- Forum: Public Area (https://www.apneaboard.com/forums/Forum-Public-Area) +--- Forum: Main Apnea Board Forum (https://www.apneaboard.com/forums/Forum-Main-Apnea-Board-Forum) +--- Thread: Help setting up Aircurve 10 cpap to bipap (/Thread-Help-setting-up-Aircurve-10-cpap-to-bipap) |
Help setting up Aircurve 10 cpap to bipap - chayes541 - 01-02-2023 I recently purchased a used bipap Resmed Aircurve 10 vauto as I could not even fall asleep with the airsense 10 after trying 6 different masks I was able to fall asleep once but the pressure was set from 4-20 and I woke up to what felt like a hurricane and wasnt able to use it again after that . I did my original test and bought equipment from lofta but they said they will not support me on the machine change so I am trying to figure out where to start with the settings and would appreciate any suggestions on where to start. After kind of playing around with some setting I feel like I can use this one I just dont know where to start. I know I need to get a sd card so I can record better data as well. My sleep study showed 22.4 RDI per hour and 17.4 AHI per hour Thanks in advance, I am so ready after years to get a good nights sleep RE: Help setting up Aircurve 10 cpap to bipap - MyNoseDoesntWork - 01-05-2023 I would just do a factory reset and then follow the setup guide. It's all in the top bar & wiki. |