I think my CPAP machine isn't working - Printable Version +- Apnea Board Forum - CPAP | Sleep Apnea (https://www.apneaboard.com/forums) +-- Forum: Public Area (https://www.apneaboard.com/forums/Forum-Public-Area) +--- Forum: Main Apnea Board Forum (https://www.apneaboard.com/forums/Forum-Main-Apnea-Board-Forum) +--- Thread: I think my CPAP machine isn't working (/Thread-I-think-my-CPAP-machine-isn-t-working) Pages:
1
2
|
I think my CPAP machine isn't working - mazrose - 05-29-2014 Hi, I'm new to this machine - I've had it for 1 week now. I found that it was a lot noisier than the original machine I used but I didn't want to take it back because I've waited 3 months for this machine! Last night the results were sad face and AHI of 0.1, the ramp is orange and the air pressure doesn't seem to increase - it stays on 4 and my air pressure is 11.5. Do you think it's broken? Desperate! RE: I think my CPAP machine isn't working - zonk - 05-29-2014 Hello mazrose and welcome See page 4, how to adjust RAMP http://www.resmed.com/au/assets/documents/product/s9_autoset/welcome_guide/368893_s9-autoset-s9-elite_welcome-guide_apac_eng.pdf All explained in the clinical manual, available via Email, section three http://www.apneaboard.com/adjust-cpap-pressure/change-cpap-pressure-settings-adjusting-your-machine-with-a-clinician-setup-manual S9 setup pictures and video http://www.apneaboard.com/resmed-s9-cpap-setup SleepyHead and ResScan software download http://www.apneaboard.com/forums/Forum-Private-Files-and-Links S9 data management guide http://www.resmed.com/au/assets/documents/product/s9_autoset/data_management_guide/368276r3_s9-series_data-mgt-guide_row_eng.pdf We want to see happy face and leak below 24 l/m Press and hold both silver buttons for 3 sec and turn the push dial The sleep report shows leak number, AHI, etc Please note the above links are compulsory for S9 users RE: I think my CPAP machine isn't working - zonk - 05-29-2014 (05-29-2014, 01:18 AM)mazrose Wrote: Do you think it's broken?We don,t know if the noise coming from the motor or from leaks, mask leaks can be quite noisy and disruptive to your sleep Good mask seal is essential for effective treatment, if you,re in US and have insurance, talk to your DME about 30 days masks trials and equipment replacement schedule, mask cushion do wear out and need replacing regularly and washing on a daily basis What was and how long you had the 'original machine'? RE: I think my CPAP machine isn't working - trish6hundred - 05-29-2014 Hi mazrose, WELCOME! to the forum.! I hope you ar able to figure out the problem with your new machine. Hang in there for more suggestions. RE: I think my CPAP machine isn't working - jaycee - 05-29-2014 When air is turned on the pressure will display in very small numbers at bottom of the screen. If the big number in middle of the screen is "4.0", that is your humidity setting, not the pressure. Frown = leaking Need to isolate where that leaking is going. An S-9 Elite should be as quiet (or likely more quiet) than anything you've had in the past (if you aren't leaking). Where does the "noise" seem to come from on the machine ?? RE: I think my CPAP machine isn't working - mazrose - 05-30-2014 for all your information!!! I went back to my sleep clinic yesterday so that they could check it and everything is fine. I think I was just getting a bit paranoiac about it. Last night results were smiley face, AHI 0.4 I don't have a humidifier. I'm not from USA - I didn't realise this forum was American based but it's fine if I can get help as & when I need it. Many thanks again. I'll keep on persevering RE: I think my CPAP machine isn't working - retired_guy - 05-30-2014 (05-30-2014, 03:10 PM)mazrose Wrote: for all your information!!! Glad you got your machine figured out Maz, About being USA based? Try not to hold it against us; we actually have many many members from as far away as Australia, New Zealand, Switzerland, Ireland, Texas,,,, We're just happy to have all of you here to help us figure all this stuff out. RE: I think my CPAP machine isn't working - zonk - 05-30-2014 (05-30-2014, 03:14 PM)retired_guy Wrote: we actually have many many members from as far away as Australia, New Zealand, Switzerland, Ireland, Texas,,,,Who moved Texas, now you need a visa to go Texas RE: I think my CPAP machine isn't working - PaytonA - 05-30-2014 Zonk, You always needed a visa to go to Texas. To Texans, the rest of us are from foreign countries. RE: I think my CPAP machine isn't working - Homerec130 - 05-30-2014 And AZ is still talking about leaving the nation. After all, we do our own border security. |