+- Apnea Board Forum - CPAP | Sleep Apnea (https://www.apneaboard.com/forums)
+-- Forum: Public Area (https://www.apneaboard.com/forums/Forum-Public-Area)
+--- Forum: Main Apnea Board Forum (https://www.apneaboard.com/forums/Forum-Main-Apnea-Board-Forum)
+--- Thread: Power loss Res Med S 9 (/Thread-Power-loss-Res-Med-S-9)
Power loss Res Med S 9 - litebeerlvr - 05-06-2012
hello I have a question Re: my Res Med S 9 . APAP machine .. I turn on the machine it activates for a few seconds and then the following messege is displayed Check RES MED 30/90 W power supply unit and fully insert connector. I have checked the power cord on both ends and reconnected it several times.with no success. Has anyone experienced this problem? If anyone has experienced this problem please advise what the solution was..
Thanks Marty
RE: Power loss Res Med S 9 - zonk - 05-06-2012
Hi Marty, welcome aboard
I've not seen this message before, can you use still the machine
Try to unplug it and disconnect humidifier, put back together, check the power brick connections, plug it again and if still getting this message than assume its faulty, might as well reported and have it exchanged. Also it would be an added bonus if ts anything other than S9 AutoSet or Elite bc if got Escape in the name its not data capable just shows compliance hours used and no efficacy data.
RE: Power loss Res Med S 9 - jdireton - 05-07-2012
Yes, I've gotten the same error but have always been able to clear it by carefully and fully pushing the machine connector in. The way I've got my machine the power is coming in from over it and that seems to want to pull the connector out slightly.
Sorry, I don't know any other solution. I would recommend that you check the pins on the connector to make sure none of them might be bent.
Always wondered how the machine had enough power to tell me it's not plugged in correctly! I guess it's smarter than I am.