DV54: default values for apnea and hypopnea detection
Hi All,
I have been fiddling with the setting for the apnea and hypopnea detection on this device (DevilBiss DV54) (because normally it doesn't distinguish between the two, which is very annoying).
Now lately after a second operation to my nose and after increasing the pressure to 12, it looks like it's finally going better. The DV also says the AHI's are going down from around 15 to around 1.
But to be sure, I'll have to make sure the settings for the detection of apea and hypopnea are back to their default/standard values. And I don't know them anymore
Does anybody know?
Thx.
RE: DV54: default values for apnea and hypopnea detection
Hi eriks!
Welcome to the forum.
I'm unsure of the model number that you show. You might want to check this link to see if any manuals are for your model.
http://www.apneaboard.com/adjust-cpap-pr...tup-manual
This is the same link that is located at the top of the page.
Good Luck.
RE: DV54: default values for apnea and hypopnea detection
Hi.
The DV54 is the proper name of the device. It is also known as "DeVilbiss SleepCube AutoAdjust" if I remember correctly.
RE: DV54: default values for apnea and hypopnea detection
Hi eriks,
WELCOME! to the forum.!
Much success to you with your CPAP therapy.
trish6hundred