Welcome to Apnea Board !
As a guest, you are limited to certain areas of the board and there are some features you can't use.
To post a message, you must create a free account using a valid email address.
Login or Create an Account
First time with APAP, requesting help with interpreting the results
Hello experts,
I have been suffering from heavy snoring for a few years and also experienced symptoms of chocking during sleep. Thus, I decided to consult a sleep specialist and without any surprise he said: 95% chance I have obstructive sleep apnea (due to my facial features). The sleep study seemed too expensive in my limited budget, so I decided to directly grab an Automatic CPAP machine and see if it helped. Today is the first time I tried it for a few hours (without humidifier) and I already feel great. However, I was wondering if anybody can please help me with:
Is there any way to confirm that I have obstructive sleep apnea by looking at OSCAR data (since I ditched the sleep test)?
Do the results look normal ? If there are any recommendations for the upcoming nights ?
RE: First time with APAP, requesting help with interpreting the results
Welcome to the forum. Congratulations on getting the best machine and getting off to a good start. Your AHI is in the treated range (<5) but there is room for improvement. Your minimum pressure is too low. Most feel starved for air at a setting of 4. Also, note that as soon as ramp ends the pressure increases quickly to a little over 10 to respond to your need and stays at that level or higher for the entire session. We generally recommend a minimum pressure setting close to the median which, in your case is 10.4. I suggest you set your minimum pressure at 9 or 10. Also turn off ramp unless you need it to fall asleep. You EPR setting of 3 is optimal. When posting data it is best to post just event flags, flow rate, pressure (not mask pressure), leak rate, and flow limits. Those are the most important and reducing the number makes the data easier to read. See the link below for how to organize your data. If you don’t know how to change settings see instructions here. https://www.apneaboard.com/resmed-airsen...setup-info Be sure to post data again after making any changes.
INFORMATION ON APNEA BOARD FORUMS OR ON APNEABOARD.COM SHOULD NOT BE CONSIDERED AS MEDICAL ADVICE. ALWAYS SEEK THE ADVICE OF A PHYSICIAN BEFORE SEEKING TREATMENT FOR MEDICAL CONDITIONS, INCLUDING SLEEP APNEA. INFORMATION POSTED ON THE APNEA BOARD WEB SITE AND FORUMS ARE PERSONAL OPINION ONLY AND NOT NECESSARILY A STATEMENT OF FACT.
Machine: Needing iVAPS but QUACKS refusing to help but they love testing Mask Type: Not using mask Mask Make & Model: F&P Vitera on shelf Humidifier: None/nada CPAP Pressure: 0-0 pressure set CPAP Software: Not using software
Other Comments: SCS PVC K9D** Untreated CA Asthma Dr. Donothings
RE: First time with APAP, requesting help with interpreting the results
I'd say it's convincing enough what's shown here. I'd give min pressure a bump to at least 7 to allow EPR 3 room to work.
INFORMATION ON APNEA BOARD FORUMS OR ON APNEABOARD.COM SHOULD NOT BE CONSIDERED MEDICAL ADVICE. ALWAYS SEEK THE ADVICE OF A PHYSICIAN BEFORE SEEKING TREATMENT FOR MEDICAL CONDITIONS, INCLUDING SLEEP APNEA. INFORMATION POSTED ON THE APNEA BOARD WEBSITE AND FORUMS ARE PERSONAL OPINION ONLY AND NOT NECESSARILY A STATEMENT OF FACT.
RE: First time with APAP, requesting help with interpreting the results
Thanks @Melman @SarcasticDave94 for your suggestions. Yesterday I bumped up the minimum pressure to 9.
Attached are the new metrics obtained. Please let me know if you have any more suggestions..
Machine: Needing iVAPS but QUACKS refusing to help but they love testing Mask Type: Not using mask Mask Make & Model: F&P Vitera on shelf Humidifier: None/nada CPAP Pressure: 0-0 pressure set CPAP Software: Not using software
Other Comments: SCS PVC K9D** Untreated CA Asthma Dr. Donothings
05-27-2021, 05:00 PM (This post was last modified: 05-27-2021, 05:01 PM by SarcasticDave94.
Edit Reason: clarify
)
RE: First time with APAP, requesting help with interpreting the results
OK, what it looks like now is some positional Apnea clusters, where your chin is tucking your chest or too many pillows. Either is kinking your neck and reducing airflow and increasing Obstructive events. Review your head and neck alignment, the pillow arrangement, and then refer to our soft collar wiki in my signature.
BTW you'll see what I'm meaning by Apnea clusters by looking at this OSCAR you posted, and look for one event after another. A good example is about 0330.
INFORMATION ON APNEA BOARD FORUMS OR ON APNEABOARD.COM SHOULD NOT BE CONSIDERED MEDICAL ADVICE. ALWAYS SEEK THE ADVICE OF A PHYSICIAN BEFORE SEEKING TREATMENT FOR MEDICAL CONDITIONS, INCLUDING SLEEP APNEA. INFORMATION POSTED ON THE APNEA BOARD WEBSITE AND FORUMS ARE PERSONAL OPINION ONLY AND NOT NECESSARILY A STATEMENT OF FACT.
RE: First time with APAP, requesting help with interpreting the results
Dave is right about positional apnea. The increased minimum pressure has reduced you flow limitations, RERA, and hypopnea. Pressure spikes appear to be associated with clustered OA which fits for positional apnea. Read the WIKI Dave suggested and also this http://www.apneaboard.com/wiki/index.php...onal_Apnea Reducing your positional apnea should reduce you AHI significantly.
INFORMATION ON APNEA BOARD FORUMS OR ON APNEABOARD.COM SHOULD NOT BE CONSIDERED AS MEDICAL ADVICE. ALWAYS SEEK THE ADVICE OF A PHYSICIAN BEFORE SEEKING TREATMENT FOR MEDICAL CONDITIONS, INCLUDING SLEEP APNEA. INFORMATION POSTED ON THE APNEA BOARD WEB SITE AND FORUMS ARE PERSONAL OPINION ONLY AND NOT NECESSARILY A STATEMENT OF FACT.
!
