Unknown Model "1130X120" (DS AVAPS 30)

[Gubbeen]

Hi folks--like so many, I find it hard to adequately express my gratitude for everyone's patience and contribution to this community.

Just acquired a vintage DreamStation AVAPS30, Model CAX1130T12C AAM H/HT/C. The previous user (whose identity is unknown to me) left behind some data and I thought I'd check my OSCAR install with it.

I got the 'unknown data profile, will probably work' msg and, sure enough, the import seems to have come off just fine.

These are the closest entries in the Supported Models list:

• DreamStation BiPAP S/T 30 with AAM (1030X150)
  
  
• DreamStation BiPAP AVAPS 30 (1130X110, 1130X200)
  

So mine looks to be a minor variation on the latter, 1130X110, but includes the 'AAM' (Auto Airway Management) functionality explicitly mentioned for the former.

I'm not sure where/how to upload the SD zip, if that'd be helpful.

[Crimson Nape]

Hi Gubbeen! -
If OSCAR is supplying the data, then you should no longer see that message. Since that is an older model, I advise not sending the data at this time. I doubt any further development will take place since we are doing good to try and provide loaders for the newer CPAP models.
- Red

[Gubbeen]

I agree that there doesn't seem like there's any actual interpretive work to be done, just an update of the whitelist (which I'd seen as a response to other tickets).

I haven't looked into the raw data, but I wouldn't have been surprised if the devs needed it just to get an arbitrary hardware ID from it.

Appreciate the quick response.