AirSense 10 Autoset User and Clinician Settings - Printable Version +- Apnea Board Forum - CPAP | Sleep Apnea (https://www.apneaboard.com/forums) +-- Forum: Public Area (https://www.apneaboard.com/forums/Forum-Public-Area) +--- Forum: Main Apnea Board Forum (https://www.apneaboard.com/forums/Forum-Main-Apnea-Board-Forum) +--- Thread: AirSense 10 Autoset User and Clinician Settings (/Thread-AirSense-10-Autoset-User-and-Clinician-Settings) |
AirSense 10 Autoset User and Clinician Settings - anderson5420 - 03-22-2021 I have had a Resmed Autosense 10 Autoset since early March. Ever since joining this Forum I have not been bashful about diving in to see what the settings are and what I might want to change. But now I am flummoxed. There USED to be a menu to set ClimateControl to Auto or Manual. I have been through both the User and Clinician menus half a dozen times, and the ClimateControl item seems no longer to be there. The one parameter I want to change is the temperature, to reduce it from its default setting. But since I can't get to that menu item, I am at a loss. The most recent OSCAR daily screenshot (attached) shows ClimateControl is set to Auto, and I would like to reset it to Manual. Would I be doing something bad if I were to choose the "Rest Defaults"? I know from my OSCAR reports what the settings have been since Day One. Thoughts? Thanks! RE: AirSense 10 Autoset User and Clinician Settings - Sleeprider - 03-22-2021 If you had a heated tube, was it plugged in when you checked these settings. Having the tube connected changes the options. RE: AirSense 10 Autoset User and Clinician Settings - anderson5420 - 03-23-2021 (03-22-2021, 08:06 PM)Sleeprider Wrote: If you had a heated tube, was it plugged in when you checked these settings. Having the tube connected changes the options.Aha! That was it. The AirSense 10 Autoset sits on a little table below the level of the bed, so I have to pick it up to be able to see the settings on the screen. In order to do that, I usually disconnect the hose. Hose reconnected, and ClimateControl option has reappeared. Thanks! |