FlashAir files DATALOG copy in 8x3 format - Printable Version +- Apnea Board Forum - CPAP | Sleep Apnea (https://www.apneaboard.com/forums) +-- Forum: Public Area (https://www.apneaboard.com/forums/Forum-Public-Area) +--- Forum: Software Support Forum (https://www.apneaboard.com/forums/Forum-Software-Support-Forum) +--- Thread: FlashAir files DATALOG copy in 8x3 format (/Thread-FlashAir-files-DATALOG-copy-in-8x3-format) |
FlashAir files DATALOG copy in 8x3 format - DrNefario - 05-03-2021 I have been successfully using a W-03 FlashAir card for 4 years. Now, I am trying to configure a 'new' FlashAir card which is an old SD-6 (gen 1 ) version for a second AirSense-10. It is in Station mode and I can either use FlashPAP or a browser to copy the files to my PC. However, all the DATALOG files filenames are shortened to 8x3 format and sleepyhead only displays "Summary Data" without graphs. Is there a fix for this? RE: FlashAir files DATALOG copy in 8x3 format - Crimson Nape - 05-03-2021 I'm guessing that it could how the card is formatted. What is the format, FAT or FAT32? RE: FlashAir files DATALOG copy in 8x3 format - DrNefario - 05-03-2021 I thought that might have something to do with it, but I checked and it is FAT32. Note that the files on the card are the long name format. If I download the files to my PC directly from the card, everything works OK. The problem is when I use wireless to download the files. t only have the original card firmware as I have been unable to locate any update for that. I have W-02 and W-03 update versions but nothing prior. Also, I'm not sure how to determine the FW version on the card. PS - Update: When I run the FlashAir.exe that came on the card, it says V1.14 (I normally configure it by editing the CONFIG file) RE: FlashAir files DATALOG copy in 8x3 format - Crimson Nape - 05-03-2021 I found a review of the original series of FlashAir cards, that was dated 2013. It states that the firmware only supports the 8.3 format. RE: FlashAir files DATALOG copy in 8x3 format - DrNefario - 05-03-2021 Okay, thanks for that clarification. It's not good news, but good to know. |