Climateline heated hose - broken or bad connection - Printable Version +- Apnea Board Forum - CPAP | Sleep Apnea (https://www.apneaboard.com/forums) +-- Forum: Public Area (https://www.apneaboard.com/forums/Forum-Public-Area) +--- Forum: Main Apnea Board Forum (https://www.apneaboard.com/forums/Forum-Main-Apnea-Board-Forum) +--- Thread: Climateline heated hose - broken or bad connection (/Thread-Climateline-heated-hose-broken-or-bad-connection) |
Climateline heated hose - broken or bad connection - Wondering2 - 12-09-2022 My Resmed heated hose (for Airsense 11) seems not to be functioning as it has previously. The heat setting is at 80F, and I used to feel the hose being just a little warm - but not so for the past few weeks. It'd like to see if the heater wire is broken, or if I've just got a bad connection at the machine's port. I'd normally use an ohm meter to check for continuity at the hose end, but there are 4 pads there, and I don't know which are for the resistance wires and which are for the thermistor leads. If I put the ohmmeter (uses 9 volt power) across the thermistor leads I can damage the thermistor. SO does anyone know which are the heater wires and which are the thermistor? |