I've searched high and low for this, but maybe not using the right terminology.
At some point, I attached my h5i to my S9 at an angle or something, and folded over the rubber gasket that seals the tube the runs between the two halves of the machine. After figuring out why it was making noise, I straightened out that seal, but it's still got a crease, so it still leaks a little.
Has anyone run into this? Is this a seal/gasket/o-ring that I can replace? I've looked for parts for the h5i, but everything seal related refers to the lid seal.
Any advice would be appreciated. Thanks!